English
45
Change Fuse for 12 V adaptor
NOTE:
Make sure that no hardware is lost when removing the fuse. Also ensure
that hardware is fitted back into the correct place.
If the device does not work when using the 12 V cigarette lighter adapter,
change the fuse. This can be found in the top of the 12 V adapter.
Unscrew the round, silver endpiece (A).
K
Remove the fuse (C) and replace it with a 2 A new time delay fuse.
K
Ensure that the silver tip (B) is fitted into the silver endpiece. Screw the
K
endpiece back on.
Connections
Private Listening with Earphones/
Headphones (Fig. 1/15; Fig. 2/4)
1. For private listening use headphones with 3.5 mm stereo jack and
connect to earphones jack ( ).
2. Press VOL+
/ VOL- to increase or decrease the volume.
WARNING:
Do not adjust the headphone volume to loud. This may be hazard-
K
ous to your hearing and you may endanger others and yourself.
Adjust to a low volume to avoid disrupting your surroundings.
K
If you suffer from tinnitus, keep volume to a minimum or refrain from
K
use of this unit.
Otologists advise a against long term use of headphones over an
K
extended period of time.
Side Panel Inputs
USB port (Fig. 1/12)
Plug a USB storage device directly into the correct port of the device.
Card slot (Fig. 1/1)
Insert an MMC/SD or MS card with the label facing back in the card slot
of the unit.
For further use with a USB storage device or memory card, please refer to
section
Page 51 “Work in Data Mode”.
Turn Unit On (Fig. 1/16; Fig. 2/2)
Turn the unit on by sliding the “ON/OFF” main switch on the side of the
unit to “ON”. The buttons / / / (Fig. 1/7) and / (Fig. 2/9) light
up red.
NOTE:
In Dual mode, the DVD MONITOR must be switched on so that the
power supply is fed to the second monitor.
