648347

AEG DDLE OKO TD 18 Manual

30
Zoom out
Zoom in
Previous page
1/100
Next page
30
Installation – for qualied contractors
INSTALLATION
7. Safety
7.1 Instructions and regulations
◦ All steps until the commissioning is completed as
well as the maintenance of this appliance must only
be carried out by a qualied contractor in accord-
ance with these instructions.
◦ Perfect function and safe operation can only be
assured when using original accessories and spare
parts intended for this equipment.
◦ Observe all locally applicable instructions and regu-
lations regarding water and electrical connections.
◦ Observe all regulations of your local water and elec-
tricity supply utilities.
◦ The specic electrical resistance of the water used
must not fall below that stated on the type plate. In a
linked water network, observe the lowest electrical
water resistance (see chapter “Application areas”).
Your water supply utility will advise you of the specif-
ic electrical water resistance or conductivity.
◦ Install the appliance only in an enclosed room free
from the risk of frost. Store the dismantled appliance
in a room free from the risk of frost, as water resi-
dues remain inside the appliance.
◦ The protection IP 25 (hoseproof) can only be en-
sured with a correctly tted cable grommet.
7.2 Water installation
◦ Cold water line
Permissible materials: Galvanised steel pipe, stain-
less steel pipe, copper pipe or plastic pipe.
◦ DHW line
Permissible materials: Stainless steel pipe, copper
pipe or plastic pipe.
◦ Operating temperatures can reach up to 60 °C. In
case of faults, loads up to 95 °C / 1.2 MPa can occur
temporarily in the installation. Any plastic pipework
used must be suitable for these conditions.
◦ A safety valve in the hot water pipe is not
permissible.
◦ Never use taps/valves for open vented equipment.
◦ If you are using thermostatic valves, observe chapter
Recommended settings.
The appliance is suitable for preheated water up to
60 °C.
The maximum permissible supply temperature is
60 °C. The appliance can be damaged by higher
temperatures. With the “central thermostat” (see
chapter “Special accessories”), the maximum sup-
ply temperature can be limited to 60 °C.
7.3 Electrical installation
◦ The power supply must be connected permanently.
◦ The appliance must be able to be separated from
the mains power supply, for example by fuses that
disconnect all poles with at least 3 mm contact
separation.
… 30 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG DDLE OKO TD 18 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG DDLE OKO TD 18 in the language / languages: English, German as an attachment in your email.

The manual is 25,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info