689107

AEG DBS3370 Manual

6
Zoom out
Zoom in
Previous page
1/48
Next page
6www.aeg.com
ENGLISH
Thank you for choosing an AEG product. In order to ensure the best results, always use original AEG accessories
and spare parts. They have been designed especially for your product. This product is designed with the
environment in mind. All plastic parts are marked for recycling purposes.
Dear Customer,
It may be possible that your steam station does not produce steam immediately after lling it with water for the
rst time or relling the tank. The reason for this is that air trapped in the inner system can delay this function a few
seconds. Please be patient and try it again by pressing the steam button. For your convenience the steam will appear
after you release the steam button for a few seconds and it is not necessary to press the button all the time. Find out
your rhythm for the best steaming result. Thank you for your kind attention and please enjoy your new steam station!
COMPONENTS
A. Steam button
B. Soft handle
C. Temperature alignment mark
D. Temperature selector
E. Temperature indicator light
F. Hot water pipe
G. Mains cable
H. Base unit
I. Anti-calc cartridge
J. Water tank
K. Maximum water level indicator
L. Stainless steel soleplate
M. Iron rest
N. Power indicator light
O. Descaling indicator light
P. Low level water indicator light
Q. Steam level indicator light (Low, Medium, High)
R. Rell reset button
S. Power button
T. Steam level control button
Picture page 2-3
GETTING STARTED
1 Before rst Remove all adhesive remains and gently rub with a dampened cloth. Position the steam gen-
erator iron horizontally on the ironing-board or on a heat resistant, secure surface at the same height as an
ironing-board. Unwind and straighten the power cord and the steam cord. When turned on for the rst time,
temporary vapours/odours may occur.
2 Remove the water tank by gripping the slot on the underside and pulling it gently away from the base unit. (A)
Detach the anti-calc cartridge and then immerse it in water for more than one minute. (B) Insert the anti-calc
catridge back. Fill the water tank using cold water. It is recommended to use destilled water or a mix of 50%
destilled, 50% tap water. Empty the water tank to rinse out any foreign particles which may remain from the
manufacturing process.
3 Always rell the water tank to MAX level using cold water (A). Insert the water tank into the base unit (B). It is
recommended to use destilled water or a mix of 50% destilled, 50% tap water. Ensure that the water tank latches
securely into place.
4 Connect the steam generator iron to the mains supply. Press the power button (A). Turn the temperature selec-
tor clockwise to maximum setting (B). The temperature indicator light on the iron will illuminate. Then, select a
steam level on the control panel, from low - medium - high steam.
5 When the temperature indicator light turns on, the steam station is pre-heating. When the light turns o, it
is ready to be used. Press and hold the steam button for about one minute to get steam. Then hold one more
minute in order to clean the steam generating system.
6 Iron an old towel, to ensure that any residues inside the iron are not transferred to the laundry. If necessary, wipe
the sole plate with a slightly damp cloth.
OPERATING INSTRUCTIONS
7 Connect the steam generator iron to the mains supply. Press the power button. When the power switch is
pressed, the power indicator will illuminate. Wait for one to two minutes, until the steam lamp lluminates. Select
the steam level between Low - Medium and High. See Ironing chart for ironing recommendation.
8 If the lower water level indicator is illuminated (A) (followed with two beep sounds), rell the water tank. After
relling the water tank, press the rell reset button (B). The rell reset button will be extinguished. Steam can
now be used again.
9 To activate the steam, press the steam button. When releasing the button, use up the steam before putting it
back on the iron rest of the steam station.
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG DBS3370 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG DBS3370 in the language / languages: English, German, Dutch, French, Portuguese, Spanish as an attachment in your email.

The manual is 2,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info