537337

AEG DBS 5558 Manual

30
Zoom out
Zoom in
Previous page
1/48
Next page
English
30
not shown
RELEASE button below the water tank. Releasing device
of the water tank
Instructions
Unpacking
• Remove any protective foils and stickers from the
soleplate.
• Please unwind the lead completely.
Electrical connection
• Make sure that the iron voltage (see name plate) and
the line voltage match.
• The mains plug should only be inserted into a cor-
rectly installed 230 V ~ 50 Hz socket with earthing
contact.
Connected Wattage
The station has a total maximum wattage of 2200 W.
With this connected load a separate supply line protect-
ed by a 16 A household circuit breaker is recommended.
CAUTION: OVERLOAD!
• If you use extension leads, these should have a
cable cross-section of at least 1.5 mm
2
.
• Do not use any multiple sockets, as this device is
too powerful.
Temperature Control on the Iron (3)
The symbols on the control correspond to the following
settings:
• (Synthetics, silk) low temperature
• • (Wool ) medium temperature
• • • (Cotton, linen) highest temperature
Water Tank (8)
• The water tank has a recessed grip on the bottom so
that it can be removed.
• The lock of the water tank is also the lime lter
cartridge. Take out the lime lter cartridge to ll with
water.
• The tank volume is 1.7 litres.
Water
Use only tap water or distilled water.
Do not ll battery water, water from the clothes dryer
and water containing additives (such as starch, perfume,
softener or other chemicals) into the water reservoir.
This could damage the iron due to residues forming in
the steam chamber. These residues may cause impuri-
ties to the fabric when dropping out of the holes in the
soleplate.
Operation
Before Initial Use
• Clean the ironing base with a slightly damp cloth.
• In order to remove all residues before initial use,
please pass the iron a few times over an old clean
cloth.
Ironing without steam
NOTE:
• Sort out the garments according to their ironing
temperatures.
• Always set the temperature control to „MIN“ before
connecting the appliance to a power point, or
before disconnecting it.
• Place the iron on the rest (6).
• Only connect the machine to a properly installed
safety socket, 230 V/50 Hz.
• Set the temperature on the temperature control (3).
If you have sensitive items to iron, please begin with
the lowest temperature.
NOTE:
The control lamp (1) on the iron shows that it is
heating up. As soon as the control lamp goes o
the operating temperature has been reached. Now
you can start ironing.
• Always turn the temperature control to „MIN“ after
use and remove the mains plug (the control lamp in
the handle goes o).
Steam Ironing
WARNING:
The iron expels a large quantity of hot steam. Danger
of burns.
CAUTION:
• When using the steam iron please ensure that the
water tank is always lled to the required level.
• The lime lter cartridge always has to be positioned
in the water tank, even if you use distilled water.
CAUTION: INITIAL USE:
Please proceed as follows:
• The tank should only be lled up to the maximum
mark. Do not overll!
• Close the water tank and place it back in the base.
• Connect the base station to a 230 V / 50 Hz socket
with earthing contact.
• Set the desired temperature within the range „• •“
to „• • •“. The control lamp on the iron lights up.
• Wait until the soleplate has heated up. Once the
temperature has been reached the control lamp
goes o.
… 30 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG DBS 5558 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG DBS 5558 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 5,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info