561428
12
Zoom out
Zoom in
Previous page
1/20
Next page
12
GB
D
N
Troubleshooting
Problem Possible cause Solution
Soleplate is not heating even though iron is
turned on.
Connection problem Check main power supply cable, plug and
outlet.
Temperature control is in MIN position. Select adequate temperature.
Iron does not produce steam. Not enough water in tank. Fill water tank (see “Getting started”, no 2).
Steam control is selected in non-steam position. Set steam control between positions of
minimum steam and maximum steam (see
“Ironing chart”).
Selected temperature is lower than that
specified to use with steam.
Select a temperature up to
.
Spray function does not work. Not enough water in tank. Fill water tank (see “Getting started”, no 2).
Steam jet and vertical steam jet function does
not work.
Steam jet function was used very frequently
within a short period.
Put iron on horizontal position and wait
before using steam jet function.
Iron is not hot enough. Adjust the proper temperature to steam
ironing (up to
). Put iron in vertical
position and wait until temperature indicator
light turns o .
The iron is leaking. The temperature setting is too low to produce
steam.
The variable steam knob must be set on “0”
position until the iron is hot .
Problem Mögliche Ursache Lösung
Bügelsohle wird trotz eingeschaltetem
Bügeleisen nicht heiß.
Verbindungsproblem Überprüfen Sie das Netzkabel, den Stecker
und die Steckdose.
Temperaturregelung be ndet sich in Stellung
MIN
Wählen Sie die geeignete Temperatur.
Bügeleisen erzeugt keinen Dampf. Nicht genügend Wasser im Tank. Füllen Sie den Wassertank (Siehe „Erste
Schritte“, Nr. 2).
Dampfregler ist nicht auf Dampferzeugung
eingestellt.
Stellen Sie den Dampfregler zwischen
minimale und maximale Dampferzeugung
(siehe „Bügeltabelle“).
Ausgewählte Temperatur ist niedriger als die für
die Damp unktion erforderliche Einstellung.
Wählen Sie eine Temperatur bis zu
.
Sprühfunktion arbeitet nicht. Nicht genügend Wasser im Tank. Füllen Sie den Wassertank (Siehe „Erste
Schritte“, Nr. 2).
Dampfstoß und Vertikaldampfstoß
funktionieren nicht.
Dampfstoßfunktion wurde sehr häu g innerhalb
kurzer Zeit verwendet.
Stellen Sie das Bügeleisen waagrecht und
warten Sie, bevor Sie die Dampfstoßfunktion
verwenden.
Bügeleisen ist nicht heiß genug. Stellen Sie die richtige Temperatur für
Dampfbügeln ein (bis zu
). Stellen Sie das
Bügeleisen senkrecht und warten Sie, bis die
Temperaturanzeige erlischt.
Das Bügeleisen ist undicht. Die Temperatureinstellung ist zu niedrig, um
Dampf zu erzeugen.
Der Dampfregler muss auf „0“ stehen, bis das
Bügeleisen heiß ist.
Fehlersuche
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG DB1384-CH at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG DB1384-CH in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info