688861

AEG AXP26U558HW Manual

21
Zoom out
Zoom in
Previous page
1/92
Next page
21
ENGLISH
1.
Drain the water collection tank
completely and leave the bottom
drain cap and rubber plug long time
enough to allow any residual water to
drain out. Once the tank is completely
drained and no more water ows out,
reinstall the rubber plug and cap.
1.
Make sure the lter and drain cap are
in place.
2.
Check the cord to make sure it is in
good condition, without cracks or
damage.
3.
Place new batteries in the remote
control.
4.
Install the air conditioner as described
in the Installation Instructions.
2.
Wash the lter using liquid
dishwashing detergent and warm
water under 40°C. Rinse lter
thoroughly. Gently shake excess
water from the lter. Be sure lter is
thoroughly dry before replacing. Or,
instead of washing you may vacuum
the lter clean.
3.
Replace the lter after the lter is dry.
Be sure lter is thoroughly dry
before replacing.
If the air conditioner will not be used for
an extended period of time:
Before using the air conditioner again:
8.3 Winter Storage
9.
TROUBLE SHOOTING
Before calling for service, review this
list. It may save you time and expense.
This list includes common occurrences
that are not the result of defective
workmanship or materials in this
appliance.
Air conditioner will not operate.
Air from unit does not feel cold enough.
Air conditioner cooling, but room is
too warm - NO ice forming on cooling
coil behind decorative front.
• Wall plug disconnected. Push plug
rmly into wall outlet.
• House fuse blown or circuit breaker
tripped. Replace fuse with time delay
type or reset circuit breaker.
• Control is OFF. Turn Control ON and
set to desired setting.
• Fault code P1 appears in the display
window. Drain water as described in
7.3 Drainage Section.
• Room Temperature lower than the set
temperature (Cool Mode) or Room
Temperature higher than the set
temperature (Heat Mode). Reset the
temperature.
• Room temperature below 16°C.
Cooling may not occur until room
temperature rises above 16°C.
• Reset to a lower temperature.
• Compressor shut-o by changing
modes. Wait approximately 4 minutes
and listen for compressor to restart
when set in the COOL mode.
• Outdoor temperature below 16°C.
To defrost the coil, set Fan mode.
• Air lter may be dirty. Clean lter.
Refer to 8. Care and Cleaning section.
To defrost, set to Fan mode.
• Temperature is set too low for nighttime
cooling. To defrost the coil, set to Fan
mode. Then, set temperature to a higher
setting.
• Exhaust duct not connected or blocked.
See 5.1 Exhausting hot air Section.
2.
Remove and clean the lter, allow it
to dry completely, then reinstall it.
3.
Remove the batteries from the
remote control.
4.
Store the air conditioner in a cool,
dry location, away from direct
sunlight, extreme temperature,
excessive dust, and well ventilated.
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG AXP26U558HW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG AXP26U558HW in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 9,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info