Remove sleeve (D) and frame (B) from the unit. Use instal-
lation keys (C), if necessary.
Place the sleeve in the ISO slot.
Bend the claws outward with a screwdriver for perfect fit.
Check the sleeve for tight fit.
Connect the ISO female connectors of the unit with the
two ISO male connectors of the vehicle.
Connect the antenna to the antenna connector at the
rear of the unit.
Secure the unit against theft, if necessary. Attach bolt and
mounting strip with the fastening materials at the firewall.
Carefully slide the unit into the sleeve until it locks into
place.
Press RESET (29) with a pen or other pointed object after
all connections are made.
Attach the front panel (A) as described under “Attach
Front Panel”
CAUTION:
Cable damage possible!
To avoid cable damage observe the cables when slid-
ing the unit into the sleeve.
Attach the frame.
Remove Unit
Follow these instructions to remove the unit:
Remove the frame.
Insert left and right installation keys in the slots left and
right (the claws are now bent back).
Slide the unit out of the sleeve.
NOTE:
Unevenness of the casing can cause the claws to lock.
Unlock the claws with the installation keys, if necessary.
Toyota or Nissan Installation
NOTE:
Sleeve, frame and mounting strip are not needed.
Use the threads on the side of the casing (A) to mount the
unit on the vehicle bracket (supplied with your car). The holes
are marked with T (for Toyota) and N (for Nissan).
Loosen the mounting screws for the hooks left and right
at the front of the unit and remove the hooks.
Mount the brackets (B) with screws on the unit (D).
Connect External Audio Device
Fold out the protective cover to the right.
Connect line out of the external audio device to AUX IN
(11) jack on the front panel.
Select playback mode for external device by repeatedly
pressing MODE/PAIR (17) until AUX is displayed.
In order to prevent soiling, close the protective cover
again when there is no device connected to the AUX IN
input.