462616
15
Zoom out
Zoom in
Previous page
1/40
Next page
- 14 -
Drehen Sie das Handrad zu sich, um die Nadel ganz nach oben zu stellen.
Heben Sie den Nähfuß an.
1. Ziehen Sie den Faden unter die Fadenführung und ziehen Sie ihn nach oben über die Fadenführung.
2. Legen Sie ihn zwischen die beiden Spannungsscheiben.
3. Führen Sie den Faden durch den Schlitz auf der rechten Seite nach unten und durch den Schlitz auf der linken Seite nach oben.
4. Ziehen Sie den Faden straff von rechts nach links, über den Fadengeber und nach unten in das Öhr des Fadengebers.
5. Legen Sie ihn in die Fadenführung.
6. Ziehen Sie den Faden nach links hinter die Nadelfadenführung.
7. Fädeln Sie von vorne nach hinten durch die Nadel ein, und ziehen Sie etwa 10 cm Faden durch das Nadelöhr.
(Siehe Seite 15 zum automatischen Einfädeln)
Turn the hand wheel toward you to raise the needle to its highest position.
Raise the presser foot.
1. Pull the thread under the thread guide and slide it up over the hook.
2. Put it between the two iron plates.
3. Guide the thread down the right side slot and up the left side slot.
4. Firmly pull the thread from right to left, over the take-up lever and down into the take-up lever eye.
5. Put it in inside the eyelet.
6. Pull the thread to the left behind the needle bar thread guide.
7. Thread the needle from front to back and pull approx. 10 cm of thread through eye of needle.
(For Auto threaded system see page 15)
EINFÄDELN DES OBERFADENS / THREADING UPPER THREAD
1
2
3
4
5
6
7
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG 679 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG 679 in the language / languages: English, German as an attachment in your email.

The manual is 3,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info