617389
51
Zoom out
Zoom in
Previous page
1/91
Next page
( 20 )
CHANGING THE NEEDLE
Turn the power switch to "OFF"
before changing the needles.
Do not use any needle which is bent or blunt.
1. Turn the hand wheel toward you until the
needles are fully raised.
2. Open the front cover and lower the presser
foot.
3. Using the hexagon wrench key from the
accessory box, loosen the needle clamp
screws and remove the needles. Upper left
screw for left needle and lower right screw
for right needle.
4. Insert the new needle with the flat side to the
back into the needle clamp, making sure it
is inserted as far up as possible. Tighten the
needle clamp screw firmly.
When the needles are set correctly, the left
needle is slightly higher than the right one.
If needles are not correctly inserted, skipped
stitches will result.
This machine is equipped with needle systems
H.A*1 (Needle are household type).
REPLACING THE BULB
Turn the power switch to "OFF" before
replacing the bulb.
1. Loosen the screw until it is taken apart.
2. Take off the lamp cover, as figure shown.
3. Push and twist and then remove the old
bulb.
4. Insert the new bulb and twist to its position.
Important:
This machine is designed to use 15 watt bulb.
The bulb is available from your local dealer.
Hexagon wrench key
Needle
(Use HA*1)
Lamp cover
Flat side to the back
Machine front
Screw
Screw
51


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG 3500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG 3500 in the language / languages: English, German, French as an attachment in your email.

The manual is 3,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info