672662
9
Zoom out
Zoom in
Previous page
1/20
Next page
CONNEXION DES ENCEINTES
SPEAKERS CONNECTIONS
VERBINDEN DER LAUTSPRECHER
BRANCHEMENT DE L’ENCEINTE GAUCHE
Connecter l’enceinte droite à l’enceinte gauche en respectant les polarité + sur le + et - sur le -. Les
fils nus et les broches s’insèrent dans le trou diamétral percé dans la tige de la borne. Voir shéma
ci-dessous.
Desserrer la bague jusqu’à ce que le trou dans la tige soit visible. Insérer la
broche ou le fil nu dans le trou, puis fixer le câble en vissant la bague de la borne.
Eviter tout risque que le métal nu des câbles de haut-parleurs ne touche la face arrière ou
un autre connecteur. S’assurer que la longueur dénudée ou la longueur de la broche ne
dépasse pas 1/2” (1 cm) et qu’il n’y a aucun brin libre.
CONNECTION OF THE LEFT SPEAKER
Connect the right speaker ( to the left speaker terminal) to the speaker terminals of the right speaker.
You must be sure that the polarity is OK, + on + and - on -.
(See schematics)
SPADE CONNECTORS
These should be slotted under the terminal’s screw bushing, which is then fully tightened.
Ensure the connector is tightly secured and there is no danger of bare metal from spade
connectors touching the back panel or another connector as this may cause damage.
BARE WIRES AND PIN CONNECTORS
Bare wires and pin connectors should be inserted into the hole in the shaft of the terminal.
Unscrew the speaker terminal’s plastic bushing until the hole in the screw shaft is revealed. Insert the
pin or bare cable end into the hole and secure the cable by tightening down the terminal’s bushing.
BANANA CONNECTORS
You also can use banana connectors on the speakers terminal.
Avoid any danger of bare metal from the speaker cables touching the back panel or
another connector.
VERBINDEN DES LINKEN LAUTSPRECHERS
Verbinden Sie den linken Lautsprecher mit dem rechten Lautsprecher. Bitte beachten Sie dabei die
Polarität (+ an + / – an - ) (sehen Sie dazu bitte auch die Zeichnung auf der vorherigen Seite).
Gabelstecker: Diese sollten unter die Schraubverschlüsse platziert werden, welche dann fest
angezogen werden sollen, um den richtigen Kontakt zu gewährleisten. Der Stecker sollte nicht die
Rückwand außerhalb des Terminals berühren, da dieses zu Beschädigungen führen kann.
Loses Kabel: Bitte führen Sie jeweils ein Kabel in das Loch des Schaftes des Schraubverschlusses.
Drehen Sie den Plastikverschluss dazu weit hoch. Danach verschrauben Sie den Verschluss wieder
fest, um einen sicheren Kontakt zu gewährleisten.
u
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Advance Acoustic AIR-150 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Advance Acoustic AIR-150 in the language / languages: English, German, French as an attachment in your email.

The manual is 4,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info