429063
13
Zoom out
Zoom in
Previous page
1/14
Next page
61180019L1-5A Issue 1, May 2004 13
NOTE
The CO X.25 network administrator must
configure the X.25 switch for the Total Access
1500 19-Inch Chassis, accomplishing tasks
such as assignment of an LDN number for the
chassis.
Connect 10Base-T
The Total Access 1500 System can provide SNMP
management capability over an Ethernet. Access to the
network is via the RJ-45 10Base-T connector,
J33,
located on the upper right side of the backplane.
WARNING
The 10Base-T Ethernet interface MUST NOT
be metallically connected to interfaces which
connect to the Outside Plant (OSP) or its
wiring. This interface is designed for use in
intra-building interfaces only. The addition of
Primary Protectors is not sufficient protection
in order to connect these interfaces metallically
to OSP wiring.
To connect the Total Access 1500 19-Inch Chassis to
the Ethernet ring, simply plug the male RJ-45 modular
connector into the female RJ-45 port,
J33, on the Total
Access 1500 19-Inch Chassis backplane. When
planning the cable run to the Total Access 1500 19-Inch
Chassis, be sure to allow enough cable for routing the
cable to the right from the backplane connector to the
frame and for tie off in accordance with CO SOP.
There are two provisional items in the SCU: Telnet port
and TCP/IP port. Specify the Telnet port to access
menus over the Ethernet, and specify the TCP/IP port to
issue TL1 commands.
Connect to PairGain Test Controller (PGTC)
Use a straight through 50-pin amp cable to connect the
PairGain Test Controller to the PGTC interface (
P5) of
the Total Access 1500 19-Inch Chassis.
P5 accepts a
female connector.
3. MAINTENANCE
The Total Access 1500 19-Inch Chassis does not require
routine maintenance for normal operation.
ADTRAN does not recommend that repairs be
attempted in the field. Repair services may be obtained
by returning the defective unit to ADTRAN. Refer to
the Warranty and Customer Service section for further
information.
4. SPECIFICATIONS
Specifications for the Total Access 1500 19-Inch
Chassis are detailed in Table 2.
Table 2. Specifications
Power Requirements
Input DC Voltage: –42 VDC to –56 VDC
DC Voltage Nominal: –48 VDC
Maximum Current: (5-amp fused) on PSU
Environmental
Operating Temperature: –40°C to 65°C
Storage Temperature: –40°C to 85°C
Relative Humidity: Up to 95% noncondensing
Physical
Dimensions: 3.50 in. H × 19.00 in. W ×
10.75 in. D
Weight fully loaded: 20 lbs.
Weight empty: 10 lbs.
Part Number
Total Access 1500 19-Inch
Chassis:
1180019L1
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Adtran total access 1500 quad line interface unit at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Adtran total access 1500 quad line interface unit in the language / languages: English as an attachment in your email.

The manual is 4,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info