661824

Adobe Premiere Elements 15 Manual

161
Zoom out
Zoom in
Previous page
1/275
Next page
156
Applying transitions and special effects
Last updated 10/4/2016
Bass
The Bass effect lets you increase or decrease lower frequencies (200 Hz and below). Boost specifies the number of
decibels by which to increase the lower frequencies.
AudioGain
Audio gain helps in normalizing audio, by either raising or lowering it to match other audio sources.
Channel Volume
The Channel Volume effect lets you independently control the volume of each channel in a stereo clip or track. Unlike
the Balance effect, Channel volume doesn’t automatically reduce the volume of one channel when you raise that of the
other. You might use this, for example, to raise the volume of a voice in the left channel without diminishing the volume
of a voice in the right. Each channel’s level is measured in decibels.
Delay
The Delay effect adds an echo of the audio clip’s sound that plays after a specified amount of time.
Delay Specifies the amount of time before the echo plays. The maximum is 2 seconds.
Feedback Specifies a percentage of the delayed signal to be added back into the delay to create multiple decaying
echoes.
Mix Controls the amount of echo.
DeNoiser (Windows only)
The DeNoiser effect automatically detects tape noise and removes it. Use this effect to remove noise from analog audio
recordings, such as magnetic tape recordings. Click the triangle beside the Custom Setup button to view the following
options:
Freeze Stops the noise floor estimation at the current value. Use this control to locate noise that drops in and out of a
clip.
Reduction Specifies the amount of noise to remove within a range of -20 to 0 dB.
Offset Sets an offset value between the automatically detected noise floor and the value that you specify. This is limited
to a range between -10 and +10 dB. Offset allows additional control when the automatic denoising is not sufficient.
Dynamics (Windows only)
The Dynamics effect helps eliminate unwanted background noise, balance the dynamic range, and reduce clipping, or
the distortion from over-amplification. Click the Custom Setup twirl-down triangle to open the following controls:
AutoGate Specifies the level (in dB) that the incoming signal must exceed. Signals below this level are muted. Use this
control to remove unwanted background noises, such as a background noise behind a voiceover.
Compressor Sets the level (in dB) at which compression occurs and the ratio at which compression is applied, up to
8:1. Also controls the attack time (the time it takes for the compressor to respond), the release time (the time it takes for
the gain to return to the original level when the signal falls below the threshold). The MakeUp control adjusts the output
level to account for loss in gain caused by compression. Use the Compressor controls to increase the volume of soft
sounds, decrease the volume of loud sounds, or both.
Expander Reduces all signals below the specified threshold to the specified ratio. The result is similar to the Gate
control, but subtler.
Limiter Sets the maximum level for signals, between -12 and 0 dB. Signals that exceed the threshold are reduced to the
threshold level.
… 161 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Adobe Premiere Elements 15 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Adobe Premiere Elements 15 in the language / languages: English as an attachment in your email.

The manual is 11,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info