802402
8
Zoom out
Zoom in
Previous page
1/168
Next page
8
17. When the appliance is used in the bathroom, remove the plug from the mains socket
after use, as the proximity of water is dangerous even when the appliance is switched off.
18. Do not allow the device to get wet. If the device falls into water, pull the plug out of the
socket immediately. Do not put your hands into the water when the device is connected to
the mains. It must be checked by a qualified electrician before being used again.
19. Do not handle the device with wet hands.
20. Always switch off the appliance before removing the plug from the socket.
21. The operating device must be supervised and within sight at all times. When leaving
the room where the device is operating, always turn it off. If the device is not working,
always remove the plug from the mains socket.
22. Do not connect the device to an automatic de-energizing device, such as a thermal
control device or a timer.
23. Keep flammable materials such as furniture, bedding, paper, clothes, curtains, etc. at
least one meter away from the device.
24. Do not cover the device during operation or place any objects on it.
25. The power cord must not be laid above or below the heater, nor should it touch or lie
near its hot surfaces. Do not place the device under an electrical outlet.
26. Heating surfaces may heat up to more than 60°C. The device should be installed in
such a place that children and pets cannot reach it.
27. The device may not be installed or used in vehicles.
28. There are parts inside the appliance that may be hot or cause sparks. Do not operate
the heater in areas where materials such as gasoline, paint or other flammable substances
are used or stored.
29. Always disconnect the device from the mains and disconnect the power cord from the
device when it is not in use or you want to clean it.
BEFORE FIRST USE:
1. After removing the packaging, make sure that the device is in good condition.
2. The packaging materials may contain plastic, nails etc., which may be hazardous and therefore should not be left within the reach of
children.
3. Keep all objects at least 1 meter from the front and sides of the appliance.
4. Do not use the device in next to a window as rain may cause the electric shock.
5. Do not use the device outdoors, or on wet surfaces. Avoid spilling liquid on the device.
WALL INSTALLATION METHOD
1. Installation MUST be carried out by a qualified electrician.
2. Do not connect the device to the mains source until it has been installed in its final location and adjusted to the position it will be used
in.
3. Avoid installation behind a door.
4. The device must not be located immediately below a socket-outlet.
5. In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this device must not be supplied through an external
switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.
6. On the wall at least 1.8 meters away from the ground, make two holes horizontally with a hole distance of about 176mm. Two metal
screws and two plastic expansion screws are attached in box together with the device.
7. Install expansion screws in the holes to keep the nail heads slightly up and project at least 4mm from the wall.
Place the device with the air outlet vent facing downwards, align the nail head with the two holes on the back of the fuselage, hang it on
the screw, and move the device appropriately so that the wall-hanging hole of the product catches the nail so as to install it firmly.
8. After the installation is completed, check the montage stability first, and then turn on the power after it is completely stable.
9. Before use, make sure that the towel rack fixing nut (4) is tightened.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Adler CR 7747 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Adler CR 7747 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish as an attachment in your email.

The manual is 3.23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info