800056

Adler AD 7968 Manual

5
Zoom out
Zoom in
Previous page
1/76
Next page
5
- First press: continuous mist with alternating 7 RGB LED colors.
- Second press (double flash): intermittent mist generation (15 second pauses) with alternating 7 RGB LED colors.
- Third press: Turns off the device (mist generation and lighting stop simultaneously).
Backlight button (O):
- First press: 7 RGB LED colors alternating.
- Second press: constantly backlight with the last glowing color.
- Third press: imitating the natural light of a burning candle mode.
- Fourth press: Turn off the backlight.
7. If there is no water in the water tank (C), the diffuser will be turned off automatically.
8. The product cannot be used if there is no water in the tank (C).
NOTE: The mist concentration may vary slightly, which is normal. Different types of water, humidity, temperature and air velocity affect
spray intensity.
9. Before replacing with another oil, please clean the device according to the maintenance instructions.
10. Never leave water in the tank (C) and disconnect the USB cable (K) when the device is not in use.
11. After working for a long time, turn off the device for 60 minutes to avoid damaging the ultrasonic wave atomizer, and then turn it on
again.
ACCIDENTAL LEAK
If you accidentally tip your device over while in use, follow these steps:
1. Turn off the power. Unplug the appliance and open the lid (B) to pour out all the remaining water from the water tank (C).
2. Gently shake the device to drain the internal water.
3. Air dry the device in a safe place for 24 hours.
DESCALING
If there is limescale deposited in the aroma diffuser caused by water, you can add white vinegar to the water to dissolve the limescale,
leave it for 20 minutes, then rinse with water. Then use a soft cloth to wipe off the water. Never use strong cleaning agents.
TROUBLESHOOTING
If this product is not working normally, please follow these steps for self- troubleshooting before sending the return to the seller:
PROBLEM 1: The product automatically turns off in one second when the N spray button is turned on.
POSSIBLE CAUSE: Inadequate amount of water.
SOLUTION: Please add water to the water tank or drain if it exceeds the MAX level.
POSSIBLE CAUSE: The USB cable is not connected to the device.
SOLUTION: Make sure the USB cable is connected to the product and to the power source properly.
PROBLEM 2: No spray or abnormal spray
POSSIBLE CAUSE: Inadequate amount of water.
SOLUTION: Please add water to the water tank if there is not enough. If the water level inside the water tank is higher than the
maximum water level mark, the mist will be sprayed irregularly, abnormally. Drain the water so that it is below the "MAX" level.
POSSIBLE CAUSE: The atomizer ceramic plate (I) is dirty.
SOLUTION: Please clean the water tank (C) and the ceramic atomizer plate (I).
POSSIBLE CAUSE: Lower air inlet holes (G) are dusty.
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Adler AD 7968 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Adler AD 7968 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish as an attachment in your email.

The manual is 2.5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info