734460

Adler AD 7934 Manual

4
Zoom out
Zoom in
Previous page
1/54
Next page
4
20. The device should be cleaned regularly with dead insects.
21. Do not touch the high-voltage grid with your hands / metal or fluorescent lamps during
operation.
USE
1. Housing
2. Protective grill
HIGH VOLTAGE 2200-2500V. Never touch the high tension grid when the
appliance is working, and should be kept away and out if reach from children.
3. High voltage grid
4. Slide-out container for dead insects
5. On / off switch
6. Fluorescent lamps - UV 8W T5 BL
17. Do not spray the device with any chemicals.
DESCRIPTION OF THE DEVICE: AD7934 Mosquitoes killer lamp
19. Do not cover the device - it can cause a fire.
Make sure that the electrical outlet you are going to use is grounded and has the correct voltage 220-240V ~ 50 / 60Hz. The device can
operate continuously for 24 hours, 365 days a year. The device is not waterproof, do not expose to rain.
15. Do not use near water, or in damp rooms.
Set it on a countertop or hang the device by the attached chain in the desired place. A height of 1.5-2.0 meters is recommended as
optimal for flies, moths and other insects, and 1.0 meter for mosquitoes. Setting in a darker place away from windows and doors has a
positive effect on the effectiveness of the device, because the sun's rays weaken the radiation strength of the UV fluorescent lamps. Turn
the device on using the switch (5). The light will attract insects.
16. The device is intended for indoor use only. The device is not suitable for use in barns,
stables and similar outbuildings.
device (RCD) in the power circuit, with residual current rating not more than 30 mA.
Contact professional electrician in this matter.
18. Do not insert any objects into the lamp.
Type of light source: UV 8W T5 BL fluorescent lamp - 2 pieces
2. Do not use chemical cleaning agents for cleaning. The device is not waterproof, do not wet clean the device. Clean the high voltage
grid (3) with a brush to get rid of the remains of insect bodies.
5. Make sure the device is dry before switching it on again.
1. Before cleaning or maintenance, unplug the device and allow it to cool down.
High voltage grid voltage 2200-2500V
CLEANING AND MAINTENANCE
4. Replacing the fluorescent lamp:
Power: 23.7W
Loosen the 4 screws on the side of the housing that does not have a switch (5). Then unscrew the 2 screws connecting the front and
rear protective grilles. Slide out the rear protective grille to get into the fluorescent lamps. Remove the fluorescent lamp by turning it
around its axis by approximately 90 ° until the latches release. Insert a new fluorescent lamp. To assemble, repeat the steps in reverse
order.
Power supply: 220-240V ~ 50 / 60Hz
3. Regularly clean the insect container (4). The container (4) slides out like a drawer.
IPX 0
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste
bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may
effect the environment. Do not dispose this appliance in the common waste bin.
Device is compliant with EU directives:
Low voltage directive (LVD)
Device is made in class I of insulation.
Device marked CE mark on rating label
Electromagnetic compatibility (EMC)
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Adler AD 7934 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Adler AD 7934 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 2,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info