Manual Ade KE 1210 Mia (page 4 of 12) (English, German, Dutch, French, Italian, Spanish)

642011

Zoom out

Zoom in

1/12

Thank you for purchasing this high-quality product made by ADE. You have acquired a

set of scales that meet the highest technical standards and are of proven quality.

Please read these operating instructions carefully before using the product for the first

time and keep them in a safe place where you can find them whenever you need the

information contained in the instructions.

1. Putting into Service

Inserting the batteries:

Open the lid of the battery compartment on the bottom of the scales and insert the three

supplied 1.5 V AAA batteries. Please observe the correct polarity of the batteries (+/-).

Safety information:

Ensure that no objects fall onto the scales; otherwise, the scales

may be damaged.

Only use a damp cloth to clean the scales. Never use solvents

or abrasive cleaners. Do not put the scales under water. You

must clean all the plastic parts of the scales immediately after

they come into contact with grease, spices, vinegar or any other

strongly spiced or coloured foods. Avoid any contact with citric

acid.

2. Operation

Switching on the scales:

Place the scales on a firm, level base. To switch-on the scales firmly press the weighing

platform, with a pressure of at least 500 g. After the scales have stabilised, they display

"0 g" / “0.0 oz” / “0 ml“ or “0.0 fl.oz“, depending on the setting. The scales are now

ready to weigh. Place the object to be weighed always concentric on the scales to

achieve an accurate weighing result.

Note: Display the scales a value after power-on, touch the tare-button to set the scales

back to “0 g”.

Units of weight:

The scales are equipped with highly sensitive touch buttons. Touching the min/unit

button (in weighing mode) allows you to change country-specific units of weight (g =

grams / oz = ounces / ml = millilitres / fl.oz = fluid ounces). Please ensure that the scales

are set to the appropriate units of weight for you.

Tare func tion:

Touching the tare-button allows you to set the scales to "0 g". Place a bowl, for example,

on the platform of the scales, touch the tare-button and in this way set the scales back

to "0 g". You can repeat this procedure as often as you like until the total capacity of the

scales (5 kg) has been reached. After you remove the item(s) to be weighed, the total

weight is displayed as a minus value.

Note: Is the weight to be tared heavier than 600 g or if the tared total weight exceeds

600 g, appears on top of the display the symbol TARE.

Automatic- / manua l switch-off the scale:

If the indicated weight does not change within approx. 20 seconds, the backlight of the

scales switches-off automatically. If the indicated weight does not change within approx.

40 seconds, the scales will automatically switch-off.

3. Timer

Set-up timer:

Press on the weighing platform to switch-on the scales. Touch the reset-button to enter

the timer mode. The display indicates on the top right the symbol and "00:00”. When

you used the timer-function once before the previous time-input appears. Touching the

reset-button for approx. 2 seconds allows you to set the time indicating back to “00:00”.

Now you can touch the min/unit-button to set the desired minutes (with persistent

touching in 10th steps) and by touching the sec-button the seconds (with persistent

touching in 10th steps). After entering the desired time, touch again the reset-button to

confirm the input. The timer runs and after expiry of time a loud peep-tone sounds for

about 60 seconds. Stop the beep by touching one of the buttons. During expiration, the

timer-function can anytime be stopped and/or required to operate by touching the reset-

button.

Note: If, within about 20 seconds after the start of the timer, no further action takes place,

the backlight of the scales and after further 10 seconds, the scales will automatically

switch-off; the timer function remains activated.

Switch between timer- and weighing mode:

If the scales are in weighing mode, touch the reset-button to enter the timer mode. The

weighing function is closed.

If the scales are in timer mode, touch the tare-button to enter the weighing mode. If the

timer was previously activated, the timer function runs unto the expiry of time, except the

function has been stopped by touching the reset-button.

4. Error Messages

“Lo“ = Indication that the battery is flat – Please replace the batteries with

three 1.5 V type AAA.

“EEEE” = Overload display – The 5 kg maximum capacity of the scales has been

exceeded. Immediately remove the load from the scales; otherwise, the

load cell could be damaged.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Ade KE 1210 Mia in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0,58 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Ade KE 1210 Mia Manual

Product: