471515
22
Zoom out
Zoom in
Previous page
1/24
Next page
21
Getting Help
For optimum quality when creating DVDs, use the Best setting
(in the MyDVD Capture window) when capturing video clips.
However, if you have limited disk space, Adaptec recommends
that you choose the Better or Good capture setting. Refer to the
Getting Help section of the Users Guide on the CD for help
estimating capture file size.
MyDVD may not be able to recognize video from a damaged or
degraded video tape.
If there are gaps in your analog video tape, MyDVD stops
capturing. To continue, start capturing a new clip after the gap.
Gaps in video footage are often caused by stops, pauses, static,
or unrecorded space in the original recording. They can also be
caused by old, damaged, or deteriorated video tapes.
Set your computer monitors screen resolution to 1024 x 768 or
higher for optimum viewing.
If you are playing your video and it is not appearing on the
MyDVD Main project window, make sure MyDVD is capturing
from the correct device.
To check your device, go to the Capture window (as shown in
Step 3 of Capturing Your Video) and under Record Settings, click
Change. Make sure Adaptec PCI Capture Device is selected.
To avoid choppy video in a captured file, especially a long video
clip, users should disable any scanning background programs
such as virus software or any CPU-loaded software.
Need Help Burning Your DVD?
In rare instances, while burning your video to DVD, an error
message may appear, such as
Bit rate too high. If this happens,
double-click the thumbnail in MyDVD’s Main project window.
Select the End Frame on the Trimming window and remove
about 5 to 10 seconds of video from the end. Close the
Trimming window, save the project and try again. If the
message persists, open the Trimming window again and check
the video for static. If the static exists on the video, trim back to
a point on the video where static does not exist.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Adaptec AVC2410 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Adaptec AVC2410 in the language / languages: English as an attachment in your email.

The manual is 1,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info