524656
5
Zoom out
Zoom in
Previous page
1/26
Next page
ENFRRU PL DE IT ES NL
EN • 5
664Y5400B
Heating System Pressure
From time to time you may need to top up the heating circuit
water level to get the required pressure in the system. The
circuit pressure is indicated by the combined temperature
and pressure gauge on the boiler control panel.
The minimum pressure when the boiler is cold should be 1
bar. The precise operating pressure required depends on the
height of the building and your installer will have informed
you of this value at the time of installation (see Starting up
section - Filling the DHW and heating circuits).
If the pressure falls below 1 bar, the boiler water pressure
switch will turn the boiler off until the pressure is restored
To restore the pressure, top up the heating circuit with water
by opening the filling valve (A) of the boiler primary circuit
and allow the system to fill. Once the pressure gauge of the
boiler control panel indicates the required pressure, close the
filling valve.
Safety valves
If water discharges from any of the safety valves, turn the boiler off and
call a service engineer.
BURNER SAFETY MECHANISM
SAFETY CUTOUT OF THE OIL OR GAS BURNER
HeatMaster® 30 N
The safety cutout indicator is located on the burner and on the
control panel.
The red warning light indicates an operating fault.
Wait 5 min before resetting the burner. To reset: press the button
located on the burner.
If the burner does not restart, call a service engineer after ensuring the
fault is not due to a power failure or low oil level in the tank.
USER'S GUIDE
BURNER TROUBLESHOOTING
For all burners, please refer to the relevant servicing and troubleshooting
instructions in the technical manual of your burner.
A
I
O
RESETTING THE BG 2000 AIR/GAS
PREMIX BURNER
HeatMaster® 30 N with BG 2000-S/35
HeatMaster® 60 N with BG 2000-S/60
HeatMaster® 70 N with BG 2000-S/70
HeatMaster® 100 N with BG 2000-S/100
The safety cutout indicator is located on the burner and on the
control panel.
1. Remove the burner cover.
2. Press the red button to restart the burner.
3. If the burner works properly, reinstall the cover.
4. If the the fault persists, call a service engineer.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ACV HEATMASTER 100 N at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ACV HEATMASTER 100 N in the language / languages: English as an attachment in your email.

The manual is 8,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ACV HEATMASTER 100 N

ACV HEATMASTER 100 N User Manual - German - 26 pages

ACV HEATMASTER 100 N User Manual - Dutch - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info