524584
11
Zoom out
Zoom in
Previous page
1/30
Next page
EN • 11
ENFRRU PL DE IT ES NL
Delta Pro S / Delta Pro Pack : 664Y4900 • E
INSTALLATION
RECOMMENDATIONS FOR THE PREVENTION
OF CORROSION AND SCALING
HOW OXYGEN AND CARBONATES CAN AFFECT THE
HEATING SYSTEM
Oxygen and dissolved gasses in the water of the primary circuit
contribute to the oxidation and the corrosion of the system components
that are made of ordinary steel (radiators, ...). The resulting sludge is then
deposited in the boiler exchanger.
The combination of carbonates and carbon dioxide in the water results
in the formation of scale on the hot surfaces of the installation, including
those of the boiler exchanger.
These deposits in the heat exchanger reduce the water flow rate and
thermally insulate the exchange surfaces, which is likely to damage
them.
Sources of oxygen and carbonates in the heating circuit
The primary circuit is a closed circuit; the water it contains is therefore
isolated from the mains water. When maintaining the system or filling
up the circuit, water renewal results in the addition of oxygen and
carbonates in the primary circuit. The larger the water volume in the
system, the larger the addition.
Hydraulic components without an oxygen barrier (PE pipes and
connections) admit oxygen into the system.
PREVENTION PRINCIPLES
1. Clean the existing system before installing a new boiler
- Before the system is filled, it must be cleaned in accordance with
standard EN14868. Chemical cleaning agents can be used.
- If the circuit is in bad condition, or the cleaning operation was not
efficient, or the volume of water in the installation is substantial
(e.g. cascade system), it is recommended to separate the boiler
from the heating circuit using a plate-to-plate exchanger or
equivalent.
2. Limit the fill frequency
- Limit fill operations. In order to check the quantity of water that
has been added into the system, a water meter can be installed
on the filling line of the primary circuit.
- Automatic filling systems are forbidden.
- If your installation requires frequent water refilling, make sure
your system is free of water leaks.
3. Limit the presence of oxygen and sludge in the water
- A deaerator (on the boiler flow line) combined with a dirt
separator (upstream of the boiler) must be installed according to
the manufacturer's instructions.
- ACV recommends using additives that keep the oxygen in
solution in the water, such as Fernox (www.fernox.com) and
Sentinel (www.sentinel-solutions.net) products.
- The additives must be used in accordance with the instructions
issued by the manufacturer of the water treatment product.
4. Limit the carbonate concentration in the water
- The fill water must be softened if its hardness is higher than 20° fH
(11, 2 ° dH).
- Check regularly the water hardness and enter the values in the
service log.
- Water hardness table :
Water hardness °fH °dH mmolCa(HCO3)2 / l
Very soft 0 - 7 0 - 3.9 0 - 0.7
Soft 7 - 15 3.9 - 8.4 0.7 - 1.5
Fairly hard 15 - 25 8.4 - 14 1.5 - 2.5
Hard 25 - 42 14 - 23.5 2.5 - 4.2
Very hard > 42 > 23.5 > 4.2
5. Control the heating water parameters
- In addition to the oxygen and the water hardness, other
parameters of the water must be checked.
- Treat the water if the measured values are outside the range.
Acidity 6,5 < pH < 8,5
Conductivity < 400 μS/cm (à 25°C)
Chlorides < 125 mg/l
Iron < 0,5 mg/l
Copper < 0,1 mg/l
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ACV Delta Pro Pack 45 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ACV Delta Pro Pack 45 in the language / languages: English as an attachment in your email.

The manual is 5,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ACV Delta Pro Pack 45

ACV Delta Pro Pack 45 User Manual - German - 30 pages

ACV Delta Pro Pack 45 User Manual - Dutch - 30 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info