660235
5
Zoom out
Zoom in
Previous page
1/12
Next page
5
Unpacking Oven
Inspect oven for damage such as dents in door or inside oven cavity.
Report any dents or breakage to source of purchase immediately.
Do not attempt to use oven if damaged.
Remove all materials from oven interior.
If oven has been stored in extremely cold area, wait a few hours before
connecting power.
Radio Interference
Microwave operation may cause interference to radio, television, or a similar
oven. Reduce or eliminate interference by doing the following:
Clean door and sealing surfaces of oven according to instructions in
Care and Cleaning section.
Place radio, television, etc. as far as possible from oven.
Use a properly installed antenna on radio, television, etc. to obtain
stronger signal reception.
Oven Placement
Do not install oven next to or above source of heat, such as pizza
oven or deep fat fryer. This could cause microwave oven to operate
improperly and could shorten life of electrical parts.
Do not block or obstruct oven louvers.
Oven may be stacked.
Install oven on level countertop surface or overshelf.
If provided, place warning label in a conspicuous place close to
microwave oven.
Outlet should be located so that plug is accessible when oven is in place.
For Enclosed Installation
For North American (UL/CSA) models, there are no installation
clearance requirements
Installation
To avoid risk of electrical shock or
death, this oven must be grounded.
The switching operation of this microwave oven can cause voltage uctuations on the
supply line. The operation of this oven under unfavorable voltage supply conditions
can have adverse effects. This device is intended for the connection to a power
supply system with a maximum permissible system impedance Zmax of 0.31 Ohm
at the interface point of the user’s supply. The user has to ensure that this device
is connected only to a power supply system which fullls the requirement above.
If necessary, the user can ask the public power supply company for the system
impedance at the interface point.
To avoid risk of electrical shock
or death, do not alter the plug.
Oven MUST be grounded.
Grounding reduces risk of electric
shock by providing an escape wire
for the electric current, if an electrical
short occurs. This oven is equipped
with a cord having a ground wire
with a grounding plug. The plug
must be plugged into an outlet that is
properly installed and grounded.
Consult a qualied electrician or
servicer if grounding instructions
are not completely understood, or if
doubt exists as to whether the oven
is properly grounded.
Do not use an extension cord.
If the product power cord is too
short, have a qualied electrician
install a three-slot receptacle.
This oven should be plugged
into a separate circuit with the
electrical rating as provided in
product specications (available
on acpsolutions.com). When a
microwave oven is on a circuit with
other equipment, an increase in
cooking times may be required and
fuses can be blown.
External Equipotential
Earthing Terminal (export only)
Equipment has secondary earthing
terminal. Terminal provides external
earthing connection used in addition
to earthing prong on plug. Located
on outside of oven back, terminal is
marked with symbol shown below.
WARNING
WARNING
B
A
B
C
Grounding Instructions
Improper use of the grounding can
result in a risk of electric shock.
WARNING
(Export/50 Hz Only)
For all international models (50 Hz)
A - Allow at least 7” (18 cm) of clearance around the top of the oven.
Proper air ow around the oven cools electrical components. With
restricted air ow, the oven may not operate properly and life of electrical
parts is reduced.
B - Allow at least 1” (2.54 cm) on sides of oven.
C - There are no clearance requirements for the back of the oven.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ACP MOC24 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ACP MOC24 in the language / languages: English as an attachment in your email.

The manual is 1,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ACP MOC24

ACP MOC24 User Manual - German - 12 pages

ACP MOC24 User Manual - French - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info