660259
10
Zoom out
Zoom in
Previous page
1/36
Next page
8
COMPONENT TESTING PROCEDURES
Illustration Component Test Results
Thermal cutout
31866P01 ...............
B5684121...............
Disconnect all wires from TCO.
Measure resistance across terminals.
Oven TCO . ............................................
Magnetron TCO........................................
Open at 300 °F (149 °C) and closed at
257 ° F (125 °C)
Open at 280 °F (137°C) and closed at
180
°F (82°C)
Diode
Discharge Capacitor
Remove diode lead from capacitor and
connect ohmmeter.
Reverse leads for second test.
in one direction and 50K or more in
the opposite direction.
NOTE: Ohmmeter must contain a
battery of 6 volts minimum.
MT2
MT1 GA TE
Triac Disconnect wires to triac.
Measure resistance from:
MT1 to MT2 ..............................................
MT1 to Gate..............................................
MT2 to Gate..............................................
All terminals to ground..............................
Caution - Do not operate oven with
wire to terminal MT2 removed.
Approximately 60
Triac 1 (top) is for motors
Triac 2 (middle) is for heater element
Triac 3 (bottom) is for microwave
Voltage check measure voltage from:
MT1 to Gate..............................................
0.8 VAC when energized. If no
voltage, check H.V. board and wiring.
Capacitors – 0.65 µf
Discharge Capacitor
Remove wires from capacitor terminals and
connect ohmmeter, set on highest
resistance scale to terminals.
Also check between each terminal and
capacitor case.
Between Terminals: Meter should
momentarily
return to over 5 M
occurs, replace capacitor.
Snubber assembly Disconnect wires to snubber.
Measure resistance across terminals ..........
Magnetron
Discharge Capacitor
Remove wires from magnetron and
connect ohmmeter to terminals. Also check
between each terminal and ground.
Between Terminals: Less than 1
Each terminal to ground measures
Note: This test is not conclusive. If
oven does not heat and all other
components test good replace the
magnetron and retest.
Microwave blower
motor
Remove all wires from motor.
Measure resistance across coil.
Approximately 30
Power relay Coil voltage – unit running
Terminal 0 to 1..........................................
Coil resistance
Terminal 0 to 1..........................................
(line voltage)
21 K
!
WARNING
To avoid risk of electrical shock, personal injury or death; disconnect power to oven and discharge capacitors
before following any disassembly procedures.
B5684123 ..............
Fan TC
............................................O .
Open at 350 °F (177°C) and closed at
17 °F (-8°C)
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ACP DS1400E - JETWAVE III at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ACP DS1400E - JETWAVE III in the language / languages: English as an attachment in your email.

The manual is 6,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ACP DS1400E - JETWAVE III

ACP DS1400E - JETWAVE III Quick start guide - English - 8 pages

ACP DS1400E - JETWAVE III Manual - English - 1 pages

ACP DS1400E - JETWAVE III Quick start guide - German, French, Spanish - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info