Page 2
3. Installation and Positioning 5. Connections and Amplifiers
Diagram Two
An adjustable wall bracket is supplied with each Aego-T satellite. To install the
wall brackets proceed as described below and illustrated in Diagram Two.
Note: It is very important that wall brackets are fitted securely. If you
are in any doubt about your ability to achieve a secure installation you
should seek professional advice and assistance.
The wall bracket is held to the wall via two screws inserted through elongated
holes in the bracket’s wall plate. No.8 (4.5mm) round-head, rather than
countersunk-head, screws should be used. The length of screw necessary and
type of wall fitting required will depend on the construction and condition
of the wall. If in any doubt seek professional advice.
Once the wall mounting locations for Aego-T satellites have been chosen use
the wall brackets themselves as templates to mark the screw positions. Loosen
the bracket adjustment screw using the allen key supplied and angle the
mounting post away from the wall plate to gain easier access to the holes.
With the screw holes drilled and appropriate wall fittings inserted, securely
screw the brackets to the wall and return the mounting post to the vertical.
Left
Front
Viewing/listening position
Right
Front
Centre
Left
Surround
Right
Surround
Alternative
or Extra Left
Surround
Alternative or
Extra Right
Surround
Subwoofer
Wall Plate
Mounting Post
Bracket Adjustment
Screw
Aego-T Wall Bracket
Aego-T Satellite and Wall
Bracket
Diagram One
4. Wall Brackets
Note: The elongated bracket holes enable some
adjustment for vertical alignment.
To attach an Aego-T satellite to a wall bracket
simply place the satellite above the bracket and
slide it onto the mounting post.
Note: Connecting cables to Aego-T satellites is best
done before they are mounted on wall brackets. See
Section 5.
Loosen the bracket adjustment screw to adjust the
satellites vertical angle. Turn the satellite on the
mounting post to adjust its lateral orientation.
