721703
50
Zoom out
Zoom in
Previous page
1/54
Next page
49
Troubleshooting
Refer to the symptoms and measures listed below before sending the projector for
repairs. If the problem persists, contact your local reseller or service center. Please
refer to "LED Indicator Messages" as well.
# Problem Solution
1
No picture and no sound or
projector does not start.
Projector power cord is not plugged into the wall outlet.
Power to the external connected devices is off.
The selected input mode is wrong.
Cables are incorrectly connected to the projector.
Remote control battery has run out.
External output has not been set when connecting
notebook computer
If you turn on the connected device prior to the projector,
pictures are displayed incorrectly.
2
Sound is heard but no picture
appears (or picture is dark).
Cables are incorrectly connected to the projector.
"Brightness" is set to minimum position.
Depending on the computer you are using, an image may
not be projected unless the signal output setting of the
computer is switched to the external output. Refer to the
computer's operation manual for how to switch its signal
output settings.
Do you use 3D viewing mode ?
When temperature inside the projector increases, the
cooling fan runs faster. If this state continues, the picture
may become dark.
3 Color is faded or poor.
Image adjustments are incorrectly set.
Make adjustments of "Color" and "Tint" in "PICTURE >
Advanced" and lower the "BrilliantColor™" value.
4 Picture is blurred; noise appears.
• Adjust the focus.
The projection distance exceeds the focus range.
There is fog on the projection window. If the projector is
carried from a cold room into a warm room, or if it is
suddenly heated, condensation may form on the surface
of the projection window and the image will become
blurred. Set up the projector at least one hour before it is
to be used. If condensation should form, remove the
power cord from the wall outlet and wait for it to clear.
(Computer Input only)
Perform Synchronization Adjustments ("Frequency" and
"Phase" Adjustment)
Noise may appear depending on the computer.
50


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Acer LU-X500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Acer LU-X500 in the language / languages: English as an attachment in your email.

The manual is 3,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info