Manual Abus ls2080 (page 16 of 43) (English, Dutch, Danish, French)

756343

Zoom out

Zoom in

1/43

5. Screw the mounting plate with 3 screws M4x10 tightly to the base-plates of

the transmitter and receiver.

6. Fix the mounting plates to the mounting brackets.

7. Repeat steps 3–7 of “Wall mounting”.

7. Putting into operation

Before aligning the photoelctric beam, connect the power supply.

You can also connect up the alarm and tamper lines after alignment.

7.1 Rough alignment with laser and LED

Important:

Never look directly into the laser beam! The laser used has a power of

<= 5 mW at a wavelength of 650 nm and belongs to Class 3a (classification

according to DIN VDI 0837).

1. Switch on the laser switch of the transmitter.

2. Align the transmitter horizontally and vertically so that the laser beam

points to the centre of the receiver. Alignment is optimal when both LEDs

of the receiver stop lighting.

3. To check: repeat steps 1 and 2 with the laser on the receiver.

The LED on the receiver gives you a first indication of the strength of the received

signal.

Alarm LED (red) and signal LED (yellow) Signal strength

Both LEDs OFF Optimal

One LED ON Adjust

Both LEDs ON Realign

7.2 Fine adjustment by voltage measurement

1. When the transmitter and the receiver are firmly mounted at the installation

location, you can make the fine adjustment of the photoelctric beam by

measuring the voltage level.

2. Switch your measuring device to the setting “DC” and select the lowest

voltage range (0-10 V DC).

3. Measure the voltage on the receiver and compare the value with the table

below.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Abus ls2080 in the language / languages: English, Dutch, Danish, French as an attachment in your email.

The manual is 0,89 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Abus ls2080 Manual

Product: