756222
16
Zoom out
Zoom in
Previous page
1/51
Next page
Putting into operation
16
1.
Loosen the smoke detector from the base of the housing by turning it anticlockwise.
Mark the drill holes through the base.
2.
Drill the holes, put in the plugs and screw in the base.
3.
Insert the battery (see the diagram ) and fasten the smoke detector by twisting it
clockwise onto the base. The detector has a safety device that prevents installation
without a battery.
4.
If you cannot fasten the smoke detector to the base:
Check whether the battery is correctly inserted and connected.
Operation and function test
The smoke detector is ready for use as soon as you put in the battery.
Under the housing cover there is an indicator lamp which flashes every 47 seconds
to show that the battery is correctly inserted and is delivering enough power to
generate an alarm.
Check the function of the smoke detector at regular intervals. Press the lower section
of the housing cover for 5 seconds. If you hear a signal, the device is working
properly and can be fastened.
Alternatively, you can use the RM test spray available from ABUS to test the smoke
detector. If the RM test spray enters the detection chamber, an alarm should sound,
so that you can test whether the detector is working properly.
Replacing the battery
If the battery is low, the smoke detector beeps once every minute (for up to 30 days)
to remind you to replace the battery.
You must change this battery when you hear this signal.
Even so, the smoke detector remains functional in this condition.
You must test the smoke detector each time you change the battery.
Carry out the test as detailed above.
Note
To ensure a long service life and reliable operation, we recommend using the
following high-quality batteries:
HSRM10000: 9V Alkaline, e.g. Duracell MN1604, Energizer 522
HSRM11000: 9V Lithium, e.g. EVE CR9V-P, Ultralife U9VL-J-P
Alarms and error signals
When the alarm threshold is exceeded, a loud alarm sounds.
The alarm continues sounding as long as there is smoke in the detection chamber.
The alarm is only switched off when there is no more smoke in the detection chamber.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Abus hsrm11000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Abus hsrm11000 in the language / languages: English, German, Dutch, Danish, French, Italian as an attachment in your email.

The manual is 0,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info