ON: Input 1 works as an input for magnetic contacts, motion
sensors and block locks.
8. See the notes on the dip switch position in the functional
descriptions of the individual modes.
4.6 Jumpers
The accessory module is equipped with three different jumper
connections, each of which have a different meaning. These
meanings are as follows:
Kickstart: This jumper is positioned next to the battery plug
connector.
If the accessory module is to be operated by battery only
(e.g. for programming), plug in the jumper or short-
circuit the connection with a screwdriver.
Fit disable: This jumper is positioned above the “O/P Fault” LED.
Plug in the jumper if the tamper contact on the rear is
not used.
Outputs: These jumpers are positioned under the cover tamper
contact.
They regulate the output behaviour of the relay. The
following sketch shows the possible settings and their
meanings.
12V
0V
12V
0V
12V
0V
Output 1 becomes +12 V if activated.
Output 1 becomes 0 V if activated.
Output 1 works as relay contact.
Each output can be set individually.
4.7 Internal piezo signaller
The built-in piezo is used to support the programming of the
accessory module. See the notes on the respective function.
Additionally, the piezo can be activated for signal reception during
the detector/function test.
