Manual Abus FU2938 (page 15 of 71) (English, German, Dutch, Danish, French, Italian, Polish)

692226

Zoom out

Zoom in

1/71

Installing the compact alarm (radio and standard versions)

1. Remove the compact alarm from the packaging. Open the external

casing and use it to mark the four drill holes for the wall fixings and

a hole for the cable feed.

2. Drill the holes accordingly and the hole for the supply cable.

3. Now pull the cable from behind through the cable hole into the

compact alarm.

4. Screw the compact alarm to the wall.

5. When tightening the screws, make sure that the rear sabotage

contact is correctly pressed into place.

6. Connect the individual wires of the connection cable to the clamps

(wired version) as described in the connector overview, or plug in

the RJ11 plug (radio version).

7. Optionally, you can insert a 1kOhm resistor between [+12V DC]

and [Siren Trig], as well as between [+12 DC] and [Strobe Trig] in

order to obtain a defined potential at the control inputs for the idle

state. This wiring method reduces disturbances to the feed lines,

thus helping to avoid accidental alarm triggering.

8. Connect the battery to the respective clamps. A short signal tone

sounds.

9. Set the jumper (12) to the right position for the diagnostic LEDs

(active or inactive), and close the casing.

Note:

When you close the casing lid, a long tone sounds. The compact alarm

then runs a self-test. If the self-test is successful, the LEDs start to flash

alternately. Opening the casing now triggers a tamper alarm.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Abus FU2938 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish as an attachment in your email.

The manual is 0,82 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Abus FU2938 Manual

Product: