21
Switch on
Press the Power button (J) to switch on the Multibox. A signal indicates that the device is
being switched on.
Switch off
Press and hold the Power button (J) to switch off the Multibox. A signal indicates that the
device is being switched off.
IR Recording
When programming IR from a remote control,
place the remote control approx. 20 cm from
Multibox. The remote control should be directed
to the top of the Multibox. Then follow the
instructions in the GEWA Connect application.
You may need to move the remote closer to the
Multibox if the programming fails, for example
due to poor batteries in the remote control.
Using relay output for Alert
When using the Alert function, it is possible to send an alert via the relay output. Connect
the relay function to to SW1 or SW2 (the one not used for scanning).
Resetting the Multibox
If you experience problems with the Multibox, press 3 times on the Power button (J) to reset
it. A signal indicates that the device is being restarted.
Sound through Multibox
By default, an Android device tries to send audio through the Multibox. Since the Multibox
has no built-in microphone, GEWA Connect will use the speaker phone on the device
(unless you connect a headset to the Multibox). If you want to use a headset connected to
the device, we recommend that you disconnect the audio profiles. This can be done in
Multibox setting in Android Bluetooth settings.