541310

AAS Tassman 4 Manual

121
Zoom out
Zoom in
Previous page
1/177
Next page
6.62 Player 121
the plate thus shortening the decay time of the sound produced by the structure. When the signal is
greater than 0, dampers are raised. Note that this damping adds to the natural damping of the plate
itself. If this input is not connected to any other module, the default value is set at 0 which implies
that the plate motion will be damped. This input is, therefore, usually connected to a Constant
module to obtain undamped motion or to a Damper module or the gate signal from a Keyboard
in order to vary the damping while playing. The second input signal is the force signal exciting the
plate and the third is a pitch modulation.
The default value of the following parameters is set at construction
• Length: the length, in meters, of the plate.
• Width: the width, in meters, of the plate.
• Frequency: fundamental frequency, in Hertz, of the plate beam when there is no pitch modu-
lation signal or when its value is equal to 0. Note that the fundamental frequency is indepen-
dent of the size of the plate. The software automatically calculates the physical parameters
necessary to obtain the required fundamental frequency. The default value of this parameter
is 261.62 Hz which corresponds to the middle C (C3) of a piano keyboard. This setting is
convenient when controlling a Plate module with a Keyboard module.
• Decay: proportional to the decay time of the sound produced by the plate.
• Number of Modes: number of modes used to simulate the object. As the number of modes
is increased, the number of partials in the sound increases but also inevitably the calculation
load.
• Excitation point-x: x-coordinate, in meters, of impact point from the lower left corner of the
plate.
• Excitation point-y: y-coordinate, in meters, of impact point from the lower left corner of the
plate.
• Listening point-x: x-coordinate, in meters, of listening point from the lower left corner of the
plate.
• Listening point-y: y-coordinate, in meters, of listening point from the lower left corner of the
plate.
Note: For more details on this module and especially the front panel controls, see the Multimode
module.
6.62 Player
The Player module is used to read sound files from a disk. This module has one input and two
outputs, the latter being the left and right channel from the signal read from the sound file. When
the sound file is mono, both output pins carry the same signal. The outputs from the Player can
… 121 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AAS Tassman 4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AAS Tassman 4 in the language / languages: English as an attachment in your email.

The manual is 1,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info