541315

AAS Strum Electric GS-1 Manual

35
Zoom out
Zoom in
Previous page
1/98
Next page
4.5 Using MIDI Loops 35
When the Auto-Strum mode is switched on, one first plays the note which should not be bended
and then the second one. The bending effect is then obtained by moving the pitch wheel or using
the aftertouch. This will only work, however, for intervals larger than one tone because otherwise
Strum always automatically triggers a hammer-on or pull-off when intervals of one or two semi-
tones are played legato.
When the Auto-Strum mode is switched off, the two notes can be played at the same time on
the keyboard. The lowest is then triggered with the bass strumming key (E5) and the second note
with the arp 4 key (G5). The note to be bended is triggered last and the bending is activated either
using aftertouch or the pitch wheel.
4.4.7 Power Chords
Power chords are equivalent to playing a fifth interval. They are referred to as chords because
they can also be interpreted as a major chord played without the third. In Strum, power chords are
obtained by playing fifth intervals on the keyboard. When two notes are played simultaneously on
the keyboard, Strum detects an interval and therefore plays the notes on different strings. It is not
always possible to play notes simultaneously when playing live and it is therefore recommended to
play the highest note of the interval slightly before the lowest. Otherwise, Strum may decide to play
the highest note on the lowest string and then will also need to voice the lowest note on the lowest
string which will result in both notes being played one after the other. A power chord voicing on
three strings is obtained by playing the root, the fifth and the root again one octave higher on the
keyboard.
Note that if you wish to obtain a power chord whenever a chord containing 3 or more notes is
played on the keyboard, you can also set the chord type in the Chords/Loop section to Powerchord
as explained in Section 4.6.
4.5 Using MIDI Loops
Reproducing complex patterns played on the guitar can rapidly become complicated and requires
to be a good keyboard player. The good news, however, is that patterns, in other words sequences
of chords and strumming keys, can easily be played using Strum’s MIDI loop player. Furthermore,
Strum is supplied with a library of MIDI loops which you can use to easily start creating a new
piece. The standard loop library is accessible directly from Strum’s interface by clicking on the
Load button of the loop player which will automatically bring you to the default MIDI loop library
folder. Loops can be used as they are or can easily be edited in a sequencer and then be played
using the Strum MIDI loop player.
It is important to note that Strum makes no distinction between MIDI signal coming from the
standard MIDI input (keyboard or sequencer) or the MIDI loop player. How Strum interprets the
MIDI signal it receives therefore depends whether the Auto-Strum mode is on or off. When it is
on, Strum will play chords as they are played on the keyboard and then trigger them again when
strumming keys are played in the loop. It is therefore usually simpler to switch the Auto-Strum
… 35 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AAS Strum Electric GS-1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AAS Strum Electric GS-1 in the language / languages: English as an attachment in your email.

The manual is 2,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info