621594

AA-Drill 77300 Manual

20
Zoom out
Zoom in
Previous page
1/39
Next page
18
e. Screw tight the object on the working table while drilling, so as to prevent
injuries and to have a precision workmanship.
f. You can place any size of drill bit you desire in the chuck which is placed below
the spindle shaft.
g. Plug the electric socket to the outlet and press “ON” the switch, then the spindle
shaft will rotate freely.
h. When drilling hold on the handle at the right side of the head frame and press
downward.
8. MAINTENANCE
Regular maintenance increases the life of your drill press.
After using the machine you have to clean it completely and lubricate all sliding
and moving parts.
Table adjustments:
a. To adjust table up or down, loosen clamp bolt
A). Then turn crank handle (B) to desired
height. Retighten clamp bolt (A) before drilling
operations.
b. To swing table 360° loosen clamp bolt (A) then
swing table to appropriate position, re-tighten
clamp bolt. For long work pieces swing table
180° and use the base as your table.
c. To tilt table loosen work table nuts (C), tilt to
desired angle and re-tighten nuts.
Spindledepth adjustments for 77300 (fig. 18):
When the hole must be drilled to a specific depth, the depth gauge should be used
as follows:
1. Make a mark on the side of the workpiece at
the proper depth level.
2. Place the workpiece on the table and lower
the spindle until the bit is even with the mark.
3. Tighten the lower stop nut until it comes into
contact with the depth stop.
4. Let the spindle return to its original position
and screw the upper stop nut until it is seated
against the lower stop nut. The holes will
subsequently be drilled at the precise depth.
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AA-Drill 77300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AA-Drill 77300 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info