671771
55
Zoom out
Zoom in
Previous page
1/68
Next page
Installation and Service Manual Upsilon-Series
55
Ignitionelectrode
Replace the ignition electrode when necessary, but certainly every 4 years.
This can be checked by reading out the ionisation current. The minimum ionisation cur-
rent has be greater than 2,0 µA at full capacity.
To read out the ionisation current follow the instructions:
From the standard blue screen display:
1. Press down the arrow buttons simultaneously for 2 seconds;
2. Continue with point 3.
From the setting level with a green screen:
3. Select using the right arrow button: Info;
4. Press the OK button;
5. Press the right arrow button until: Burners
6. Press the OK button;
7. Press the right arrow button until: Flame.
The ionisation currunt is shown here in µA. With the + and - button the value of burner
A and B can be shown (heat exchanger symbol turns from A to B).
If the sight glass is damaged, the complete ignition electrode has to be replaced.
Replace as follows:
- Remove the plug connections of ignition electrode;
- Push the clips on either side of the electrode to the outside and remove the electrode;
- Remove and replace the gasket;
Assembly is done in reverse order.
Condensatecontainer(refertog.13.3.cande)
Take precautionstopreventcondensatefallingon electronicsandotherboiler
partsduringdismantlingtoavoiddamageoftheseparts.
- Remove the short clamping bars (7 and 8) by loosening them a quarter of a turn. In
doing so, pay attention to the turning direction (red check cams).
- Pull the clamping bars forward and away from underneath the condensate container.
- Carefully push the condensate container (12) down and remove it from the front;
- Replace the condensate container gasket by a new one.
- Clean the polluted condensate container with water and a hard brush.
- Check the condensate container for any leakages.
Assembly is done in reverse order.
Ensure proper all around sealing of the gasket when installing the condensate container.
Ensureduringassemblythattheclampingbarsareproperlypositioned.Theyhave
tobeinaverticalposition.
Duringmaintenancealwaysreplacethegasketsofdismantledparts.
Flame
0.00 uA
gure 13.3.h
55


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for A.O. Smith Upsilon UB-110 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of A.O. Smith Upsilon UB-110 in the language / languages: English as an attachment in your email.

The manual is 9,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of A.O. Smith Upsilon UB-110

A.O. Smith Upsilon UB-110 User Manual - English - 2 pages

A.O. Smith Upsilon UB-110 Additional guide - English, Dutch - 2 pages

A.O. Smith Upsilon UB-110 Installation Guide - Dutch - 72 pages

A.O. Smith Upsilon UB-110 User Manual - Dutch - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info