503271
51
Zoom out
Zoom in
Previous page
1/126
Next page
6.3.3 Protection for the solar heating system
6.3.3.1 Drain-back tank
The solar heating system may optionally be equipped with a drain-back tank. The tank fills
itself with the heating fluid when there is no heat demand. This avoids overheating of the
solar heating system. The high insulation factor of the tank also protects the system
against freezing of the fluid. The use of the drain–back tank also serves to extend the
useful life of the fluid.
The existence of a drain-back tank is set during the installation (see section 9.2.8.1).
Refer to the solar heating system manual for more details.
6.3.3.2 Fluid temperature
The heat exchanger of the solar heating system is filled with glycol. If the temperature of
the heating fluid is too high, a signal is sent to the controller of the solar collector and the
pump of the solar collector is switched off. This signal is passed to the controller by
temperature sensor S
1
.
Safety Description
Maximum temperature:
- S
1
> 130 ºC
The pump of the solar heating system switches off
when the temperature of the heating fluid at S
1
exceeds the maximum value. The solar heating
system enters error mode. The error is also visible
on the display of the water heater.
6.3.4 Safety of the solar heating system
6.3.4.1 Expansion vessel
The solar heating system must be equipped with an expansion vessel. An expansion vessel
serves to limit pressure variations in the system. The expansion vessel in the solar heating
system can withstand a maximum pressure of 600 kPa (6 bar). The supply pressure to the
expansion vessel depends on the static head of the system.
The system is protected from overpressure by an expansion valve (see section 6.3.4.2) as
well as the expansion vessel.
6.3.4.2 Expansion valve
The solar heating system is equipped with an expansion valve. The expansion valve
monitors the pressure in the solar heating system. Should the pressure become higher
than 600 kPa (6 bar), the valve will open. The hot water can now flow out of the
installation. The valve remains open until the unsafe situation has passed, i.e. until the
pressure has fallen back to below 600 kPa (6 bar).
Note
Because a closed system is pressurized and is not filled automatically, the system will
have to be filled (see section 7.9.1) again when the expansion valve has been activated.
A system with a drain-back tank is not pressurized and does not have an expansion valve.
n
0311753_SGS_28-120_II_UKUK_V2.0 , 2017-05-03 51
51


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for A.O. Smith SGS 30 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of A.O. Smith SGS 30 in the language / languages: English as an attachment in your email.

The manual is 5,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of A.O. Smith SGS 30

A.O. Smith SGS 30 User Manual - German - 128 pages

A.O. Smith SGS 30 Usermanual and installation guide - Dutch - 120 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info