503225
99
Zoom out
Zoom in
Previous page
1/118
Next page
Code and description Cause Measure
F11 (blocking error)
Flame detection with
closed gas control valve.
Defective gas control valves See F07.
F18 (blocking error)
Communication error
No power supply at solar controller Check that there is power to the solar
heating system controller
2. The measured voltage must be 230
VAC (-15%, +10%)
No cable or damaged cable Check the wiring (communication cable)
between the main controller and the solar
heating system controller
If cable missing, connect the cable
If cable damaged, replace the cable
Short circuit Q/T–sensor Check whether the Q/T-sensor is connected
correctly to the controller.
Disconnect the Q/T-sensor.
In case of disappearing communication
error, the Q/T-sensor must be replaced.
F19 (blocking error)
Power supply voltage is
too low.
There is not enough supply voltage. Check that there is power to the
controller
The measured voltage must be 230 VAC
(-15%, +10%)
1.
2.
C02 (lock out error)
Error message from the
controller.
Incorrect reference voltage from the AD
converter.
Reset controller.
Check that the frequency of the power
supply is compliant. If not, contact your
installation engineer
If the frequency is correct but the error
persists, replace the controller.
1.
2.
3.
Internal error message
from the controller.
EEPROM read error
50 Hz error
Internal communication error
Internal error message
from the controller.
Gas valve relay error
Safety relay error
Ignition relay error
RAM error
EEPROM error
EEPROM contents do not match the
software version
Processor software error
C03 (blocking error)
Reset error
Too many resets in too short a period Wait for the error to disappear (maximum 1
hour). If the error does not disappear,
replace the water heater controller.
C04 (blocking error)
Appliance selection error
Incorrect water heater selection /
Incorrect selection resistor
Check whether the correct water heater
is selected.
If the correct water heater is selected, fit
the correct selection resistor.
If incorrect water heater selected, select
the correct one.
1.
2.
3.
C05 (blocking error)
Error message from the
solar controller
Incorrect reference voltage from the
AD converter.
EEPROM error
Reset controller.
Check that the frequency of the power
supply is compliant (see section 12.1). If
this is not the case, contact your
installation engineer.
If the frequency is correct but the error
persists, replace the solar controller.
E01 (blocking error)
The temperature
protection at the top of
the tank has been
activated.
The temperature of the water at the top
of the tank is > 88 ºC.
None. This is a temporary message that
may appear from time to time, but will
disappear automatically.
0311732_SGE_40-60_II_UKUK_V2.0 , 2017-05-03 99
99


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for A.O. Smith SGE 60 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of A.O. Smith SGE 60 in the language / languages: English as an attachment in your email.

The manual is 4,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of A.O. Smith SGE 60

A.O. Smith SGE 60 User Manual - German - 120 pages

A.O. Smith SGE 60 User Manual - Dutch - 114 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info