503225

A.O. Smith SGE 60 Manual

90
Zoom out
Zoom in
Previous page
1/118
Next page
The display will now show INTERNAL CHECK for about 10 seconds, and will then go
to the main menu.
Activate ON mode by going through the following steps:
Press once on the blue arrow [
]
to position the cursor beside ON, then press
[ENTER].
Confirm the selection START OPERATION with [ENTER].
If there is no heat demand, then
raise T
set
. (see section 4.3.3) Note the original
setting. Draw some hot water off to create heat demand.
Check whether the heating cycle runs correctly (see section 4.1.1).
If you have adjusted T
set
,
return it to the original value (see section 4.3.3).
Remove the plastic cover on the top of the appliance.
Check the supply and burner pressures (see section 7.9.2) and adjust them where
necessary.
Check that all components of the chimney flue system are properly attached.
Check the pressure differential across the pressure switch (see section 7.9.5) and, if
this is too low, the heat exchanger should be cleaned (see section 10.3.2).
Test the operation of the overflow valve of the protected cold supply setup. The
water should spurt out.
Check the drainage pipes from the discharge points of all valves and remove any
scale deposits that may be present.
Drain the water heater, see draining (see section 7.10.2).
10.2 Water-side maintenance
To do water side maintenance:
Descale the tank (see section 10.2.1)
Clean the condensate drain (see section 10.2.2)
10.2.1 Descale the tank
Scale and lime build-up prevent effective conduction of the heat to the water. Periodic
cleaning and descaling prevents build-up of these deposits. This increases the service life
of the water heater, and also improves the heating process.
Take the rate of scale formation into account when deciding on the service interval. Scale
formation depends on the local water composition, the water consumption and the water
temperature setting. A water temperature setting of maximum 60°C is recommended for
the prevention of excessive scale build-up.
To guarantee a good, watertight seal around the cleaning opening, replace the gasket,
washers, bolts and, if necessary, the lid with new parts before reassembly (see the figure).
A special set is obtainable from the supplier/manufacturer.
To simplify descaling and cleaning of the tank, the water heater is equipped with two
cleaning openings.
7.
-
-
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
•
•
90 Installation, Maintenance and Service part
… 90 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for A.O. Smith SGE 60 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of A.O. Smith SGE 60 in the language / languages: English as an attachment in your email.

The manual is 4,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of A.O. Smith SGE 60

A.O. Smith SGE 60 User Manual - German - 120 pages

A.O. Smith SGE 60 User Manual - Dutch - 114 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info