503225
86
Zoom out
Zoom in
Previous page
1/118
Next page
9.2.9.2 Switching on the solar pump
This menu lets you switch on the pump in the solar heating system manually. Call up this
menu as follows:
[ ]: SETTINGS SOLAR | TEST SOLAR PUMP.
The following display appears.
When START is selected, the pump will start to run for two minutes. Once the 2 minutes
have elapsed, the pump stops running again.
9.2.9.3 Setting the solar limit
The solar limit temperature is the maximum water temperature obtained in the appliance
via the solar heating system (measured by sensor T
1
).
This value can be set between 65 and 80 °C. The default value is 65 °C.
If you set the solar limit higher than the set point (see section 4.3.3), then the solar pump
will be started in order to heat the water further once the set point has been reached.
However, this only makes sense if the solar heating system is actually generating heat.
This makes use of the difference between the temperature at the top of the solar collector
(S
1
) and that in the appliance (measured by S
2
).
Call up the menu for the solar limit as follows:
[ ]: SETTINGS SOLAR | SOLAR LIMIT.
Please refer to the table (see section 12.1) for the adjustment range and default value for
each appliance.
9.2.9.4 Setting the solar difference
The solar difference is a value that influences how the operating cycle of the water heater
proceeds. Call up the menu as follows:
[ ]: SETTINGS SOLAR | SOLAR DIFFERENCE.
Please refer to the table (see section 12.1) for the regulation interval and default value for
each water heater.
9.2.9.5 Setting the Q/T sensor
The energy contribution of the solar heating system can be calculated (see section
9.2.9.6)
using the Q/T sensor. This calculation is only possible if your installation is
equipped with such a Q/T sensor. If this is the case, then you must set this value to YES,
otherwise NO. Call up the corresponding menu as follows:
[
]: SETTINGS SOLAR | Q/T SENSOR.
86 Installation, Maintenance and Service part
86


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for A.O. Smith SGE 60 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of A.O. Smith SGE 60 in the language / languages: English as an attachment in your email.

The manual is 4,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of A.O. Smith SGE 60

A.O. Smith SGE 60 User Manual - German - 120 pages

A.O. Smith SGE 60 User Manual - Dutch - 114 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info