671742
55
Zoom out
Zoom in
Previous page
1/92
Next page
If necessary, create a heat demand:
Use a hot water draw-off point to tap water, or
Raise the setpoint of the water temperature, refer to Set the water
temperature (see section 4.2.2).
Wait until the measured value on the CO
2
meter remains stable for some time. This
can take several minutes.
Compare the full load measured value to the value from the appendix Gas details
(see section 13.3).
The CO
2
value at full load must be within ±1.0 vol% of the CO
2
value stated in the
table.
Caution
When the CO
2
value is not correct, refer to General errors (see section
12.1.1), CO
2
value (at full load) is not correct.
Do not use the water heater when the CO
2
value is not correct and this is not
caused by the restrictor, venturi, venting system or gas category:
Switch off the appliance.
Turn off the gas supply.
Put the cover back on the water heater.
Contact your supplier.
c
Set parameter 201 to Lo, refer to section Settings (see section 10).
Wait until the measured value on the CO
2
meter remains stable for some time. This
can take several minutes.
Compare the measured value to the value measured under full load.
The CO
2
value at partial load must be within ±0.3 vol% of the CO
2
value measured
under full load.
If necessary, use a hex driver to adjust the adjuster screw until the CO
2
value is
correct.
Turn the screw clockwise for a higher CO
2
value.
Turn the screw anticlockwise for a lower CO
2
value.
If applicable, set the temperature value back to the original value (parameter 002).
Set parameter 201 to dIS, refer to Settings (see section 10).
Press [RESET]. The water heater goes into OFF mode.
Set the control switch on the side of the water heater to 0 to turn off the water
heater.
Remove the measurement probe of the CO
2
meter from the test nipple and place the
cap (1) back on the nipple (2).
Shut off the gas supply.
Fig. CO
2
value
1
2
1. Cap
2. Test nipple
6.
-
-
7.
8.
9.
10.
11.
12.
a.
b.
13.
14.
15.
16.
17.
18.
0312266_INNOVO_UKUK_V3.0, 2017-02-10 55
55


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for A.O. Smith Innovo IR 32-285 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of A.O. Smith Innovo IR 32-285 in the language / languages: English as an attachment in your email.

The manual is 7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of A.O. Smith Innovo IR 32-285

A.O. Smith Innovo IR 32-285 Usermanual and installation guide - German - 92 pages

A.O. Smith Innovo IR 32-285 Usermanual and installation guide - Dutch - 92 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info