671735
88
Zoom out
Zoom in
Previous page
1/92
Next page
13.6 Warranty
To register your water heater, you can complete and return the enclosed warranty card.
You can also register your water heater on-line through the A.O. Smith website.
Article 1: General warranty
If, after verification and at the sole discretion of A.O. Smith, a component or part (with
exclusion of the glass lined steel tank) of a water heater supplied by A.O. Smith proves
within two years of the original installation date to be defective or fails to function
correctly due to manufacturing and/or material defects, then A.O. Smith shall repair or
replace this component or part.
Article 2: Tank warranty
If, after inspection and at the sole discretion of A.O. Smith, the glass-lined steel tank of a
water heater supplied by A.O. Smith proves within 3 years of the original installation date
to be leaking due to rust or corrosion occurring on the water side, then A.O. Smith shall
offer to replace the defective water heater with an entirely new water heater of equivalent
size and quality. The warranty period given on the replacement water heater shall be
equal to the remaining warranty period of the original water heater that was supplied.
Notwithstanding that stated earlier in this article, in the event that unfiltered or softened
water is used, or allowed to stand in the water heater, the warranty shall be reduced to
one year from the original installation date.
Article 3: Conditions for Installation and Use
The warranty set out in Articles 1 and 2 will apply solely under the following conditions:
The water heater is installed under strict adherence to A.O. Smith installation
instructions for the specific model, and the relevant government and local authority
installation and building codes, rules and regulations in force at the time of
installation.
The water heater remains installed at the original site of installation.
The water heater is used exclusively with drinking water, which at all times can
freely circulate (a separately installed heat exchanger is mandatory for heating saline
water or corrosive water).
The tank is safeguarded against harmful scaling and lime build-up by means of
periodic maintenance.
The water temperatures in the heater do not exceed the maximum setting of the
thermostats, which form a part of the water heater.
The water pressure and/or heat load do not exceed the maximum values stated on
the water heater rating plate.
The water heater is installed in a non-corrosive atmosphere or environment.
The water heater is connected to a protected cold water supply arrangement, which
is approved by the relevant authority; with sufficient capacity for this purpose;
supplying a water pressure not greater than the working pressure stated on the
water heater; and where applicable by a likewise approved temperature and
pressure relief valve; fitted in accordance with installation instructions of A.O. Smith
applying to the specific model of water heater, and further in compliance with the
government and local authority installation and building codes, rules and regulations.
The water heater is at all times fitted with cathodic protection. If sacrificial anodes
are used for this, these must be replaced and renewed when, and as soon as, they
are 60% or more consumed. When power anodes are used, it is important to ensure
that they continue to work properly.
88 Installation, Maintenance and Service part
88


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for A.O. Smith Innovo IR 12-160 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of A.O. Smith Innovo IR 12-160 in the language / languages: English as an attachment in your email.

The manual is 7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of A.O. Smith Innovo IR 12-160

A.O. Smith Innovo IR 12-160 Usermanual and installation guide - German - 92 pages

A.O. Smith Innovo IR 12-160 Usermanual and installation guide - Dutch - 92 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info