671886
22
Zoom out
Zoom in
Previous page
1/28
Next page
22
22
3. FOR THE USER
3.1 Instructions for use
3.1.1 Lighting the heater
WARNING:
An accredited installer must install the heater and
commission it.
3.1.2 Filling the heater
1. Fit the drain cock and check that it is closed.
2. Open the cold-water tap to the heater and all hot-
water outlets in order to remove all air from the
system. The heater has been filled when cold water
runs out of all outlets.
3. Close all the hot-water taps. The heater is now under
pressure.
3.1.3 Commissioning
1. Check that the heater is filled with water and that the
gas supply to the heater is on;
2. Turn the temperature dial clockwise as far as it will
go;
3. Switch the supply voltage on by operating the bipolar
main switch.
4. Set the ‘I/0’ switch on the control box to ‘I’.
5. Turn the temperature control knob to the desired
position, preferably to approx. 60°C. The ventilator
burner will now ignite.
3.2 Operation
The water temperature is controlled by the control
thermostat in the control box on the column. If the
temperature in the water heater drops below the set
value, the control will send a voltage signal to the
ventilator burner. The burner automation of the ventilator
burner will then ignite the burner and keep it burning until
the control ceases to supply voltage signals.
High water temperatures cause more calcium
precipitation in the water heater. Moreover, the stand-by
losses of the water heater are greater with higher water
temperatures.
Therefore, it is recommended to set the control
thermostat to approx. 60°C
For reasons of safety, the water heater is equipped with a
high-limit thermostat and an overheating cut-out. If the
high-limit thermostat is activated, the heater is not locked
and the control thermostat will take over the temperature
control again as soon as the high-limit thermostat is
deactivated.
If the overheating cut-out is activated, it must be reset
manually after the water has cooled down.
Upon resetting, the water heater will resume its operation
in the usual way.
3.3 Shutting down
For brief periods:
1. Turn the temperature control knob fully clockwise and
set the ‘I/0’ switch to ‘0’.
For longer periods:
1. Switch off the supply voltage
(operate bipolar main switch).
2. Close the inlet gas valve;
3. Close the water supply tap.
4. Empty the heater to prevent frost damage.
3.4 Maintenance
Maintenance should be carried out at least once a year in
accordance with the recommendations of A.O. Smith.
Failure to carry out adequate maintenance may render
the warranty void. We recommend that you take out a
maintenance contract with your installer.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for A.O. Smith COF 199 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of A.O. Smith COF 199 in the language / languages: English as an attachment in your email.

The manual is 0,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info