503219
89
Zoom out
Zoom in
Previous page
1/100
Next page
Instruction manual BFC 89
gis
16 Warranty (certificate)
To register your warranty, you should complete and return the enclosed
warranty card, after which a warranty certificate will be sent to you. This
certificate gives the owner of an appliance supplied by A.O.Smith Water
Products Company B.V. of Veldhoven, Netherlands (hereinafter "A.O.Smith")
the right to the warranty set out below, defining the commitments of A.O.Smith
to the owner.
16.1 General warranty
If, after verification and at the sole discretion of A.O.Smith,
a component or part (with exclusion of the tank) of a water heater supplied by
A.O.Smith
proves within one year of the original installation date to be defective or fails to
function correctly due to manufacturing and/or material defects, then A.O.Smith
shall repair or replace this component or part.
16.2 Tank warranty
If, after inspection and at the sole discretion of A.O.Smith,
the glass-lined steel tank of a water heater supplied by A.O.Smith
proves within 3 years of the original installation date to be leaking due to rust or
corrosion occurring on the water side, then A.O.Smith shall offer to replace the
defective water heater with an entirely new water heater of equivalent size and
quality. The warranty period given on the replacement water heater shall be
equal to the remaining warranty period of the original water heater that was
supplied. Notwithstanding that stated earlier in this article, in the event that
unfiltered or softened water is used, or allowed to stand in the water heater, the
warranty shall be reduced to one year from the original installation date.
16.3 Conditions for
Installation and use
The warranty set out in articles 1 and 2 will apply solely under the following
conditions:
a. The water heater is installed under strict adherence to A.O.Smith
installation instructions for the specific model, and the relevant
government and local authority installation and building codes, rules and
regulations in force at the time of installation.
b. The water heater remains installed at the original site of installation.
c. The water heater is used exclusively with drinking water, which at all
times can freely circulate (a separately installed heat exchanger is
mandatory for heating saline water or corrosive water).
d. The tank is safeguarded against harmful scaling and lime build-up by
means of periodic maintenance.
e. The water temperatures in the heater do not exceed the maximum
setting of the thermostats, which form a part of the water heater.
f. The water pressure and/or heat load do not exceed the maximum values
stated on the water heater rating plate.
g. The water heater is installed in a non-corrosive atmosphere or
environment.
h. The water heater is connected to a protected cold supply arrangement,
which is: approved by the relevant authority; with sufficient capacity for
this purpose; supplying a pressure no greater than the working pressure
stated on the water heater; and where applicable by a likewise approved
temperature and pressure relief valve, fitted in accordance with
installation instructions of A.O.Smith applying to the specific model of
water heater, and further in compliance with the government and local
authority installation and building codes, rules and regulations.
89


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for A.O. Smith BFC80 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of A.O. Smith BFC80 in the language / languages: English as an attachment in your email.

The manual is 3,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of A.O. Smith BFC80

A.O. Smith BFC80 Usermanual and installation guide - German - 100 pages

A.O. Smith BFC80 User Manual - Dutch - 116 pages

A.O. Smith BFC80 Manual - Dutch - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info