Manual A.O. Smith ADMR80 (page 85 of 96) (English)

503235

Zoom out

Zoom in

1/96

Instruction manual ADMR 85

gis

16 Warranty (certificate)

To register your warranty, you should complete and return the enclosed

warranty card after which a warranty certificate will be sent to you. This

certificate gives the owner of a appliance supplied by A.O. Smith Water

Products Company B.V. of Veldhoven, The Netherlands (hereinafter

"A.O. Smith") the right to the warranty set out below, defining the commitments

of A.O. Smith to the owner.

16.1 General warranty

If within one year of the original installation date of a water heater supplied by

A.O. Smith, following verification, and at the sole discretion of A.O. Smith, a

section or part (with exclusion of the tank) proves to be defective or fails to

function correctly due to manufacturing and/or material defects, then A.O. Smith

shall repair or replace this section or part.

16.2 Tank warranty

If within 3 years of the original installation date of a water heater supplied by

A.O. Smith, following inspection, and at the sole discretion of A.O. Smith, the

glass-lined steel tank proves to be leaking due to rust or corrosion occurring on

the water side, then A.O. Smith shall offer to replace the defective water heater

with an entirely new water heater of equivalent size and quality. The warranty

period given on the replacement water heater shall be equal to the remaining

warranty period of the original water heater that was supplied. Notwithstanding

that stated earlier in this article, in the event that unfiltered or softened water is

used, or allowed to stand in the water heater, the warranty shall be reduced to

one year from the original installation date.

16.3 Conditions for

Installation and use

The warranty set out in article 1 and 2 will apply solely under the following

conditions:

a. The water heater is installed under strict adherence to A.O. Smith

installation instructions for the specific model, and the relevant

government and local authority installation and building codes, rules and

regulations in force at the time of installation.

b. The water heater remains installed at the original site of installation.

c. The appliance is exclusively used with drinking water, which at all times

can freely circulate (a separately installed heat exchanger is mandatory

for heating salt water or corrosive water).

d. The tank is safeguarded against harmful scaling and lime buildup by

means of periodic maintenance.

e. The water temperatures in the heater do not exceed the maximum

setting of the thermostats, which form a part of the water heater.

f. The water pressure and/or heat load do not exceed the maximum values

stated on the water heater rating plate.

g. The water heater is installed in a non-corrosive atmosphere or

environment.

h. The water heater is connected to a protected cold supply arrangement,

which is: approved by the relevant authority; with sufficient capacity for

this purpose; supplying a pressure no greater than the working pressure

stated on the water heater; and where applicable by a likewise approved

temperature and pressure relief valve, fitted in accordance with

installation instructions of A.O. Smith applying to the specific model of

water heater, and further in compliance with the government and local

authority installation and building codes, rules and regulations.

i. The appliance is at all times fitted with cathodic protection. If sacrificial

anodes are used for this, these must be replaced and renewed when,

and as soon as, they are 60% or more consumed. When electric anodes

are used, it is important to ensure that they continue to work properly.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of A.O. Smith ADMR80 in the language / languages: English as an attachment in your email.

The manual is 2,5 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of A.O. Smith ADMR80

A.O. Smith ADMR80 User Manual - Dutch - 104 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

A.O. Smith ADMR80 Manual

Product: