566837

4G Systems XSJack T3e Manual

21
Zoom out
Zoom in
Previous page
1/72
Next page
21
English
Acoustic Monitoring / Babyphone
Your XSJackT3 can monitor the audio level of its environment using a
connected telephone with a sensitive microphone or hands-free talking
function. If detected noises exceed a specific level, a configurable
number is dialled to be able to listen to the happenings at home when
being out. This function can be used as a baby phone, a burglary alarm
system or similar.
Before monitoring can be started, it must be configured using the code
L1. The sensitivity is a value between 0 and 5 where 1 means low sen-
sitivity (alarm is triggered only on heavy continued noise) and 5 means
high sensitivity (alarm is already triggered on slight short noise). It is
recommended to start with high sensitivity and to go down step by step
if you feel that alarm is triggered too often. Sensitivity 0 is a special
case where no alarm is triggered and only calls from the configured
telephone number are answered (see below).
Place the telephone receiver or the hands-free telephone in an appro-
priate position where the microphone is uncovered and near the poti-
ential source of noise. Monitoring can be started with code L3. After
acknowledgement, you must stay in off-hook state all the time and
must not put down the telephone receiver on-hook again. When being
on-hook for 10 seconds, an alarm is triggered and the configured num-
ber will be called to indicate that the telephone is not actively monito-
ring anymore.
After monitoring has been started, the system is calibrated, which is
indicated by the signal strength LEDs flashing. It is essential to be quiet
in this phase. 30 seconds after calibration, the system will be finally
armed.
In armed state, the XSJackT3 will trigger an alarm and call the destina-
tion number if, depending on the configured sensitivity level, a specific
amount of noise is detected using the microphone of the connected
telephone. The called party can then listen to the action at home,
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for 4G Systems XSJack T3e at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of 4G Systems XSJack T3e in the language / languages: English, German as an attachment in your email.

The manual is 2,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of 4G Systems XSJack T3e

4G Systems XSJack T3e User Manual - English - 33 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info