ENGLISH-6
INSTALLATION
INSTALLATION
Installation of the Projector and Screen
Refer to the drawing and table below for determining the screen size and projection distance.
Top View
Side View
Screen size
[inches (m)]
a [inches (m)]
Min. Max.
40 (1.0) 65 (1.7) 78 (2.0)
60 (1.5) 98 (2.5) 117 (3.0)
80 (2.0) 131 (3.3) 157 (4.0)
100 (2.5) 163 (4.1) 196 (5.0)
120 (3.0) 196 (5.0) 236 (6.0)
150 (3.8) 246 (6.2) 295 (7.5)
200 (5.0) 328 (8.3) 394 (10.0)
Angle Adjustment
Use the foot adjusters on the bottom of the
projector to adjust the projection angle. It is
variable within 0˚ to 9˚ approximately.
1. Lift up the front side of the projector,
and pressing the foot adjuster button,
adjust the projection angle.
2. Release the button to lock at the desired
angle.
3. Use the rear foot adjuster to adjust the
left-right slope. Do not force the foot
adjuster screws. This could damage the
adjusters or cause the lock to fail.
a
Lens center
Screen
CAUTION • Install the projector in a suitable environment according to
instructions of the accompanying manual “Product Safety Guide” and this
manual.
• Please basically use liquid crystal projector at the horizontal position.
If you use
liquid crystal projector by the lens up position, the lens down position and the side up
position, this may cause the heat inside to build up and cause damage.
Be especially
careful not to install it with ventilation holes blocked.
• Do not install LCD projector in smoke effected environment. Smoke residue may
buildup on critical parts (i.e.LCD panel, Lens Assy etc.).
CAUTION • Do not release the foot adjuster button unless the projector is
being held; otherwise, the projector could overturn or fingers could get
caught and cause personal injury.
Foot Adjuster
Press the foot adjuster button
Rear Foot Adjuster
Variable within the range of approximately 0˚-9˚
The projection distances shown in the table below are
for full size (800 x 600 dots)
a: Distance from the projector to the screen. (±10%)
Table 1 Installation Reference
