5555
11
Zoom out
Zoom in
Previous page
1/37
Next page
3M 1998 3M Multimedia Projector MP8610 7
Section 4: Operating Instructions
4-1. Projector Start Up
Read the Important Safeguards before operating the MP8610 projector. After all cable connections have
been completed, the projector can be powered up. For best results, please observe the following start up
sequence. Refer to Figure 4-1
!
Caution
Allow a projector that has been stored in a cold place
to warm up to room temperature before applying
power.
1.
Press the power switch
(1)
to ON to apply
power to the projector (
|
= ON,
O
= OFF).
The
red
LED
(3)
will illuminate.
2.
Press the Standby button
(2)
. The
green
LED
(3)
will illuminate and an image will
appear and grow brighter on the screen.
3.
Check all ventilation slots and clear away
any obstructions.
4.
Turn the lens
(4)
to focus the image.
5.
Press the foot lock button
(5)
to release the
height adjustment feet.
6.
Raise/lower projector body to extend or
retract feet
(6)
to obtain best image height.
Rotate feet
(7)
for fine adjustment.
7.
Power up your computer source and video
source(s).
9
Note
In most cases, the projector will automatically adjust
to the graphic mode of your computer by selecting a
pre–programmed setting. See Appendix C-2.
Figure 4-1. Projector Setup
4-2. Standby Mode
When the projector is not being used, place it into standby mode.
1.
Press the Standby button.
2.
The lamp will switch off and the
red
LED
will illuminate.
3.
Press the standby button again to illuminate
the lamp and project an image on the screen.
9
Note
In standby mode, the fan motor will continue to run
for a few minutes until the projector cools down.
MP8610
8610-11A
5
6
1
2
3
7
4
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for 3m MP8610 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of 3m MP8610 in the language / languages: English as an attachment in your email.

The manual is 0,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of 3m MP8610

3m MP8610 User Manual - German - 32 pages

3m MP8610 User Manual - Dutch - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info