654489
23
Zoom out
Zoom in
Previous page
1/31
Next page
20
3M 1996
3M Multimedia Projector MP8030
Section 6: Lamp Replacement
6-1. Metal Halide Projector Lamp
If the projected image appears dark or the LAMP indicator light comes on, the lamp may be getting old and in
need of replacement. Press and hold the TIMER
TIMER
button for two seconds to display the number of
operating hours for the current projector lamp. Under normal operating conditions, the lamp should last
approximately 2000 hours. After that time, the lamp will slowly grow dimmer.
For best results, replace the lamp after 2000 hours of usage.
Note
The LAMP indicator will come on if the lamp becomes too hot. If this happens, wait for the fan motor
to stop running, turn the power off and let the projector cool. Check for airflow blockage, clean the
air filter then turn the power on. If the LAMP indicator comes on again, call customer service or your
dealer.
6-2. Replacing the Lamp
To replace the lamp, the following is needed:
D Phillips screwdriver
D Standard #2 screwdriver
D Metal halide lamp
Important
Always use lamp type: 260W Metal Halide,
70 VDC, 4.3A, Part Number
78-6969-8262-4.
Power OFF: Press the Standby/ON
button on the projector control panel or remote control and wait for
the fan motor to cycle off. Then, turn off the power switch and unplug the power cord.
!
There are high voltage parts inside the cabinet that may cause an electric
shock. Always unplug projector when changing the lamp.
!
Lamp and adjacent metal parts become extremely hot and can cause
severe burns to your fingers. Allow the projector to cool for at least 1
hour before replacing the lamp.
Remove Lamp Access Door: The lamp access door
is located on the back of the machine on the right
side (Figure 6-1). Use a phillips screwdriver to
unscrew the lamp cover retaining screw and gently
open the cover and set it aside.
Note
The screw is a self-containing screw that
cannot be removed from the cover.
Lamp
Access
Door
Screw
Lamp
Module
Figure 6-1. Lamp Access Door
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for 3m MP8030 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of 3m MP8030 in the language / languages: English as an attachment in your email.

The manual is 0,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info