654485
30
Zoom out
Zoom in
Previous page
1/36
Next page
3M
Personal Projector MP7630B/MP7730B
30
© 3M IPC 2001
Lamp Replacement
Note: For maximum lamp life, do not shock, handle or scratch the lamp glass when it is hot.
Also, do not use an old or previously used lamp as a replacement lamp.
WARNING
To reduce the risk of electrical shock, always turn off projector and disconnect
power cord before changing lamp.
To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes
before replacing the lamp.
To reduce the risk of cuts to fingers and damage to internal components, use caution when
removing lamp glass that has failed and shattered into sharp pieces.
Caution
To reduce the risk of cuts to fingers and/or decreasing image quality by touching the
lens, do not insert hand into the empty lamp compartment when the lamp has been
removed.
This lamp contains mercury. Consult your local hazardous waste regulations and dispose
of this lamp in a proper manner.
1. Turn the main power switch off and disconnect the power cord from the outlet.
2. Loosen screw and remove the lamp cover. If the lamp is hot, avoid burns by waiting 45 minutes
until lamp has cooled.
3. Loosen two screws designated by arrows below. (It is strongly recommended to use a magnetic-
headed screwdriver, if possible. Pull the handle to remove lamp housing. If the screws are not
loosened completely, they could damage your fingers. Do not insert your hand into the box after the
lamp is removed. If the optical parts inside are touched by hand, it could cause color unevenness, etc.
4. Replace the lamp with the new one, insert into projector, and tighten the screws. Firmly tighten
the lamp screws. Loose screws may cause a bad connection, which may result in a malfunction.
5. Re-install the lamp cover and tighten the screw. Do not turn on the power with lamp cover removed.
Whenever the lamp has been replaced, reset the total operation time of the lamp. Do not reset if the
lamp was not replaced, as this could cause breakage.
Maintenance
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for 3m MP7630B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of 3m MP7630B in the language / languages: English as an attachment in your email.

The manual is 1,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of 3m MP7630B

3m MP7630B User Manual - German - 36 pages

3m MP7630B User Manual - Dutch - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info