534678

3Dprintingsystems UP Plus Manual

40
Zoom out
Zoom in
Previous page
1/56
Next page
UP Plus
3D Printer User Manual
CAUTION: It is strongly recommended that you
remove the model from the
5.1
Removing the raft
The first part that the printer lays down is referred to as the Raft. In order to remove the raft from
the model if the base of the model is flat is easiest using the spatula by sliding it bet
and the model and then sliding left and right in between the model. Pulling the raft off by hand
will normally cause ABS fatigue marks (were the ABS plastic goes white from stress). You can
easily get the original colour of the ABS back with
mover).
4.
Troubleshooting
3D Printer User Manual
v 2013.6.10
CAUTION: It is strongly recommended that you
wear
safety glasses and
remove the model from the
Perfboard
or the support material from the model
Removing the raft
The first part that the printer lays down is referred to as the Raft. In order to remove the raft from
the model if the base of the model is flat is easiest using the spatula by sliding it bet
and the model and then sliding left and right in between the model. Pulling the raft off by hand
will normally cause ABS fatigue marks (were the ABS plastic goes white from stress). You can
easily get the original colour of the ABS back with
a slight brushing of Acetone (nail varnish r
Troubleshooting
safety glasses and
gloves to
or the support material from the model
.
The first part that the printer lays down is referred to as the Raft. In order to remove the raft from
the model if the base of the model is flat is easiest using the spatula by sliding it bet
ween the raft
and the model and then sliding left and right in between the model. Pulling the raft off by hand
will normally cause ABS fatigue marks (were the ABS plastic goes white from stress). You can
a slight brushing of Acetone (nail varnish r
e-
… 40 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for 3Dprintingsystems UP Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of 3Dprintingsystems UP Plus in the language / languages: English as an attachment in your email.

The manual is 7,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info