477803
33
Zoom out
Zoom in
Previous page
1/115
Next page
Mounting Electrical Installation
33
2N
®
Helios IP resetting procedure
1. Switch 2N
®
Helios IP off.
2. Connect the jumper into the resetting (default setting) position (put the
display switch into the F_RES position in the display-equipped models).
3. Switch 2N
®
Helios IP on and wait for the acoustic start signalling.
4. Switch 2N
®
Helios IP off.
5. Remove the jumper from the resetting (default setting) position (put the
display switch into the NORMAL position in the display-equipped models).
6. Switch 2N
®
Helios IP on.
Name plate
backlighting
Default
settings
Display connector
jumpers
PCB version 530v2
Display connector
jumpers
PCB version 535v1
Table 2.5 Configuration Jumpers on Display Connector
To reset the default values of a display-equipped 2N
®
Helios IP, put the switch in the
display right-hand bottom corner in position F_RES.
Figure 2.13 Resetting Procedure Display Model
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for 2N Helios IP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of 2N Helios IP in the language / languages: English as an attachment in your email.

The manual is 3,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info